Beko DV6120X - Manuals - manualsarea.com

Page 3 - Important safety information; General safety; Never operate your dryer without the

3 EN 1 Important safety information This section includes safety information that will help protection from risks of personal injuries or materialistic damages. Failure to follow these instructions shall cause any warranty and reliability commitment to become void. General safety • Never place the m...

Page 5 - Installation; Ventilation hose and connection (for

5 EN It is the customers responsibility to arrange a suitably qualified installer to correctly install this product. C Preparation of location and electrical installation for the product is under customer’s responsibility. B Installation and electrical connections must be carried out by a qualified ...

Page 7 - Things to be done for energy saving:; Make sure that you; Laundry suitable for drying in the; Initial preparations for drying; A B C; Laundry unsuitable for drying in the

7 EN Things to be done for energy saving: • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them. Thus, the drying time is shortened and energy consumption is decreased. • Pay attention ...

Page 8 - Preparing laundry for drying; • Chec; Correct load capacity

8 EN • Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads should not be dried in the dryer. • Do not use fabric softeners and anti-static products unless they are recommended by the manufactu...

Page 9 - Selecting a Program and Operating Your Machine; Control panel; Filter cleaning warning light

9 EN 1 2 3 4 5 6 Ready to Wear Ready to Iron Ready to Iron Ready to Wear Extra dry Cottons Delicates Freshen Up Synthetics Timer Programmes 10 min 20 min 40 min 60 min Clean Filter End / Anticrease Drying Ready to Iron Ready to Wear On / Off Buzzer Cancel Reset 3’’ Start/Pause 4 Selecting a Program ...

Page 11 - environmental conditions and voltage fluctuations.; Program selection and consumption table

11 EN * : Energy Label standard program (AS/NZS 2442) All values given in the table have been fixed according to standard laboratory conditions. These values may deviate from the table according to the laundry type, laundry spin speed, environmental conditions and voltage fluctuations. Program selec...

Page 12 - Auxiliary function; Buzzer Cancel Models Equiped; Warning indicators; Filter cleaning; Starting the programme; Progress of program

12 EN Dry” programme instead of “Iron Dry” programme. 2. Select the “Extra Dry” programme by rotating the programme selection button. 3. Press “Start/Pause/Cancel” button to start the programme. C Press "Start/Pause/Cancel" button for 3 seconds to cancel the programme or turn the programme s...

Page 13 - Technical Specifications; Ending the program through canceling; As the inside of the dryer will be; End of program

13 EN on the “Start/Pause/Cancel” and “Cancel audio warning” buttons simultaneously for 3 seconds. To start a new program after the program is over or to interrupt the program, the childproof lock should be deactivated. To deactivate the childproof lock, press the same buttons for 3 sec. C Child-pro...

Page 14 - Maintenance and cleaning; Filter Cartridge / Door Inner Surface

14 EN 5 Maintenance and cleaning Filter Cartridge / Door Inner Surface Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Filter Cartridge”. C Such fibre and lint are generally formed during wearing and washing. C Always clean the filter and the inner ...

Page 15 - Solution suggestions for problems

15 EN Drying process takes too much time • The filter mesh may be clogged. Wash with water. Laundry come out wet at the end of drying.• The filter mesh may be clogged. Wash with water. • Excessive laundry might have been loaded in. Do not overload the machine.Machine does not switch on or the progra...