Azden 31IT - Manuals - manualsarea.com

Page 2 - Receiver Descriptions; The 311DRH True Diversity VHF Half-Rack Receiver:; from the A to B LED is a normal function of the system.

Thank you for purchasing AZDEN’S “PERFORMANCE SERIES” wireless system. This manual covers the 311DRH, 311DR, 221R, 211R and 200R receivers and the 32BT (Lavaliere), 31XT (Plug-in XLR), 31HT (Handheld), 31LT (Lavaliere) and 31IT (Instrument) transmitters. Receiver Descriptions The 311DRH True Diversi...

Page 3 - and/or remoted using coax cable if needed.

(4) Antenna connections. On the 311DRH the antennas are connector mounted (BNC) so that the supplied antennas can be disconnected and/or remoted using coax cable if needed. (5) 12-Volt Input. Plug the supplied AC adaptor into the 12-volt input on the receiver and then into a 110-120 VAC electrical o...

Page 4 - The 311DR True Diversity VHF Receiver:; from the A to B LED is a normal operation of the system.

The 311DR True Diversity VHF Receiver: The 311DR contains two separate receivers, each operating on the same frequency. The incoming signal is constantly monitored by a diversity circuit, which switches automatically to the receiver with the stronger RF signal. This allows wireless performance that ...

Page 6 - 11R Single channel VHF receiver:; The 211R features a 1/4-inch output jack and volume adjustment.

(5) Output (unbalanced) Using a suitable audio cable (not supplied), connect the 1/4-inch phone jack end of the audio output on the receiver, and connect the other end of the cable to the mic/line input of an audio mixer or amplifier. Please note that the 221R has two outputs, one for Ch.A and one f...

Page 7 - 00R Single channel VHF receiver:; The 200R features a 1/4-inch output jack and volume adjustment.

(6) Frequency label Indicates what frequency (in MHz) the receiver operates on. The AZDEN transmitter in use must also be on the same frequency. 200R Single channel VHF receiver: The 200R features a 1/4-inch output jack and volume adjustment. (1) Power/Receiving LED When the receiver is plugged in, ...

Page 8 - TRANSMITTER DESCRIPTIONS; 2BT Lavalier Microphone with body-pack transmitter:; in use must also be on the same frequency.

TRANSMITTER DESCRIPTIONS Model 32BT: Lavalier microphone with body-pack transmitter. Ideal for speaking applications such as Lecturers, Actors, Actresses, etc. Model 31XT: Plug-in XLR transmitter turns any dynamic metal-bodied microphone with XLR output into a wireless microphone. Model 31HT: Handhe...

Page 10 - 1HT Handheld Microphone Transmitter:

Removing the 31XT: Push down on the release button and pull out. (1) Turn the bottom half of the case counter-clockwise until it is completely off. (2) Insert one fresh alkaline “AA” battery into the compartment. Make sure battery polarity is correct. Replace the bottom half of the case and turn clo...

Page 11 - 1LT Lavalier Microphone with body-pack transmitter:

(3) The frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receiver in use must also be on the same frequency. (4) 3 Position Switch The bottom position: OFF The middle position: STANDBY The top position: ON In the “STANDBY” position, the audio is muted. (5) L...

Page 12 - OPERATING THE SYSTEM

(2) Insert one fresh Alkaline 9-volt battery into the compartment. Make sure the battery polarity is correct. (3) Frequency Label The Frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receiver in use must also be on the same frequency. (4) 31IT 1/4-inch plug ...

Page 13 - sound is distorted, lower the input gain on the transmitter.

the receiver to a mic/line input on your audio mixer or amplifier. Plug the receiver’s AC adaptor into the 12V input jack on the receiver, and then plug it into the 110-120 VAC electrical outlet. With the volume of your mixer or amplifier set to minimum level, turn your system’s power on. Turn on th...