ATD ATD-3723 - Manuals

ATD ATD-3723 – Manual in PDF format online.

Manuals:

Manual

Manual ATD ATD-3723

Summary

Page 2 - : Severe personal injury could occur if the user fails to; Irregular darkening or dimming; WARNING; : User must stop using the auto-darkening welding

WARNING : Severe personal injury could occur if the user fails to follow the above-mentioned warnings, and/or fails to follow the operating instructions. TROUBLESHOOTING z Irregular darkening or dimming Headband has been set unevenly and there is an uneven distance from the eyes to the filter’s lens...

Page 3 - ADJUSTING THE FIT OF THE HELMET; the helmet firmly on the head without it being too tight.; INSTRUCTIONS FOR USE

z The ATD auto-darkening welding helmet comes assembled but before it can be used it must be adjusted to fit the user properly and set up for response time, sensitivity and shade level. ADJUSTING THE FIT OF THE HELMET z The overall circumference of the headband can be made larger or smaller by rotat...

Page 4 - ADJUSTING ANGLE OF THE MASK IN THE DOWN POSITION; holes thus fixing the position of the tilt plate.; SELECTING SHADE LEVEL; referring to the; shade guide table; Turn the shade control knob on the; SELECTING DELAY TIME

ADJUSTING ANGLE OF THE MASK IN THE DOWN POSITION z If the lens is not properly aligned with the eyes in the down position the mask angle can be further adjusted into one of three preset positions using the tilt plate shown in fig.2. Behind each pivot knob on the sides of the helmet there is a screw ...