ATD ATD-10538 - Manual
ATD ATD-10538 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Read and understand all instructions.; Safety warning and precautions
- Page 4 – Additional safety regulations; WARNING
- Page 6 – Initial Operating; Always use the correct supply voltage:; The power supply voltage must match; Stepless Speed Control
- Page 7 – Do not make any adjustments while the motor is in motion.
- Page 8 – Keep the ventilation slots; clear from dirt, clean off the accumulated dust and oil; During normal operation,; if anything happens, the power supply should be cut off; Wear hearing protection.
ATD-10538
3/8” Electric Drill
Tool specifications:
Rated Voltage: (V)
120
Rated Frequency: (Hz) 60
Rated current: (A)
3.3
No-load Speed: (RPM) 0-2700
Speed Selection:
Yes
Right/Left Rotation:
Yes
Chuck Size:
3/8” (10 mm)
Drilling Capacity (max):
- Steel: 3/8” (10 mm)
- Wood: 3/4” (20 mm)
Net Weight:
3 lbs (1.4kg)
WARNING – To reduce the risk of injury, please read this instruction manual before use.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Intended use The ATD10538 drill is intended for impact drilling in brick, concrete as well as fordrilling in wood, metal, ceramic and plastic. Electrical safety The electric motor has been designed for 120V only. Always check that the powersupply corresponds to the voltage on the rating plate. Doubl...
4. Power tool use and care. a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it is designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that canno...
Initial Operating Always use the correct supply voltage: The power supply voltage must match the information quoted on the tool identification plate. Switch (Fig.1) This tool is started and stopped by pressing and releasing the switch (9). The speed can be adjusted in the high gear or in the low gea...
