APW Wyott VCG - Manuals

APW Wyott VCG – Manual in PDF format online.

Manuals:

Manual

Manual APW Wyott VCG

Summary

Page 2 - IMPORTANT FOR FUTURE REFERENCE; Model Number

2 IMPORTANT FOR FUTURE REFERENCE Please complete this information and retain this manual for the life of the equipment. For Warranty Service and/or Parts, this information is required. Model Number Serial Number Date Purchased Notes:

Page 4 - SAFETY INFORMATION; Cordset Configuration:

4 2. SAFETY INFORMATION APW Wyott toasters are designed, built, and sold for commercial use and should be operated by trained personnel only. Clearly post all CAUTIONS, WARNINGS and operating instructions near each unit to insure proper operation and to reduce the chance of personal injury and/or eq...

Page 5 - DIMENSIONS

5 DIMENSIONS 10.05” 13.20” CAUTION HOT 23.90” 22.644” 20.44” 20.88” 21.77” CAUTION HOT 0 1 POWER 560

Page 7 - Do not; Figure 1 Diagram

7 5. CLEANING Cleaning Instructions Toaster is for DRY BUNS ONLY. Do not put buttered bread products in the toaster. Note: To save time at closing (it will take 15 minutes for toaster to cool down), you might want to have the day shift clean the toaster. 1. Turn off (7) Main Power Switch (See Fig. 1...

Page 9 - TROUBLESHOOTING GUIDE; Removing Release Sheet

9 Release Sheet Kit Release Sheet Replacement 1. Turn toaster off. 2. Remove the top cover. 3. Remove old release sheet from the toaster platen (grill).!!! CAUTION !!! TOASTER PLATEN MAY BE HOT. 4. If the reverse side of the release sheet is still good, then fold the release sheet the opposite way a...

Page 10 - Discharge chute has been lifted up and a pan

10 No heat and conveyor belts don’t move. Toaster is installed incorrectly. Review and perform installation and operation procedures. Lid not placed on top securely. Install or adjust lid so that the push button plunger on the top of the toaster is depressed. Manual High Limit switch tripped open. R...

Page 11 - Manual Reset Thermostat; going to the platen until a person resets it.

11 Problem Possible Cause Corrective Action re Crown and / or heel must be forced into the toaster. Toaster is overheating or cooling fan is not turning properly. Toaster making noise or unusual sounds. (Note that some noise is inherent to the normal operation of the toaster and does not requi field...

Page 12 - PREVENTATIVE MAINTENANCE SCHEDULE; Daily

7. PREVENTATIVE MAINTENANCE SCHEDULE Tools required: Heat Resistant Gloves, Standard Cleaner, Standard Sanitizer, Soft Towels. Needle Nose Pliers, Soft Brush Phillips Screwdriver, Standard Lubricating Oil 1) Preventative Maintenance - Toaster may be hot. Allow to cool before cleaning. Use heat resis...

Page 13 - Monthly

13 3) Preventative Maintenance - Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt. Monthly WARNING! A. In addition to the daily cleaning described above, remove and clean silicone belt...

Page 17 - PARTS LIST - VCG TOASTER; ITEM NUMBER

10. Procedure: Orange Silicone Belt Tracking Conveyor belt tracking is checked at the factory. New toasters should not need adjusting. If, after replacing the orange silicone belt as described under the periodic maintenance procedure, it begins to "walk" toward one end of the conveyor or ano...

Page 18 - Remove the pin from the splice using the needle-nose pliers.; PROCEDURE FOR CHANGING A BELT

Turn the screw counter clock-wise about a half turn. If the belt has walked over the right sprocket, you will need to put it in the center of the sprockets by hand. CAUTION!!! THE BELT MAY BE EXTREMELY HOT. YOU COULD BURN YOURSELF. No No No No Yes Yes Yes Yes Did the belt walk off the sprocket in 5 ...

Page 19 - APW WYOTT EQUIPMENT LIMITED WARRANTY

19 12. APW WYOTT EQUIPMENT LIMITED WARRANTY APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the following conditions:This warranty applies to the original owner only and is not assignable.Should any product fail to function in ...