APW Wyott M95-2-JIB - Manuals

Page 2 - APW Wyott; IMPORTANT FOR FUTURE REFERENCE

takes pride in the design and quality of our products. When used as intended and with proper care and maintenance, you will experience years of reliable operation from this equipment. To ensure best results, it is important that you read and follow the instructions in this manual carefully. Installa...

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; TABLE OF CONTENTS; personnel or the equipment. The words are defined as follows:

2. IMPORTANT SAFETY INSTRUCTIONS ! ! WARNING: Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and size and install the proper electrical ...

Page 5 - GENERAL INFORMATION

5 3. GENERAL INFORMATION Check the rating label for your model designation and electrical rating. The Rating Label is located on the bottom front of the control panel. Overall dimensions with feeder: M952: 208VAC, 2780W, 13.4Amps, 60Hz or 240VAC, 2780W, 11.6Amps, 60Hz 208/250V: NEMA 6-20P Plug, 4 fo...

Page 6 - FIGURE 1; Replace top and bottom control panels.; FIGURE 2; TO ADJUST; on the rating label. Outlets must be properly grounded.; DO; OPERATING INSTRUCTIONS; over the surface of the roller.

2 1 Top Control Panel Conveyor Assembly Bottom Control Panel Feeder Conveyor Hanger Main Power Switch FIGURE 1 a. To adjust the conveyor up into the drive gear, turn the conveyor adjustment screw clockwise. Use a 7/16-end wrench to tighten the jam nut. b. To adjust the conveyor away from the drive g...

Page 8 - Also needed; FIGURE 3; Clean grill surface; TROUBLESHOOTING GUIDE

Also needed : (Wet) terry towel Catch pan for food soil (Butter Pan can be used) Common kitchen scraper If Teflon sheet is installed remove it when Bun Grill Toaster is . Step 1. Set the toaster temperature to 350°F. Step 2. Scrape loose food particles with scraper into Butter Pan under grill plate....

Page 9 - TOP

9 Buns will not toast Wrong temperature setting Excessive cupping of bun surface Increase temperature setting and allow two cycles to warm up. Verify bun cut to bun specificationCheck conveyor adjustment Buns are stale, use fresher buns. Buns toast unevenly Excessive cupping of bun surfaceConveyor p...

Page 10 - EXPLODED VIEW

29 40 8 7 3 18 45 33 57 5 17 16 48 10 34 35 6 58 52 2 42 4 46 39 44 47 1 49 62 56 55 11 15 26 36 54 32 30 22 38 37 64 20 63 53 50 51 25 19 61 43 23 59 60 27 41 21 24 9 12 28 65 10. PARTS LIST w/EXPLODED VIEW EXPLODED VIEW 65 64 63 62 61 6 21 51 2 58 60 16 32 33 56 8 1 57 12 14 31 30 13 34 9 10 29 50...

Page 11 - PARTS LIST

PARTS LIST ITEM PART NUMBER DESCRIPTION QUANTITY 11 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 84229 84217 84118 84220 84146 84213 83065 83061 89301 84164 85...

Page 12 - APW WYOTT EQUIPMENT LIMITED WARRANTY

12 11. APW WYOTT EQUIPMENT LIMITED WARRANTY APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the following conditions:This warranty applies to the original owner only and is not assignable.Should any product fail to function in ...