American Dynamics ADSDUHOVRC - Manuals

Page 3 - SpeedDome; Installation Guide–Continuation; To the Installer; Tamperproof; Purchase or Supply Separately; Male BNC connector; Tools Required; Torx bit

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 3 of 12 SpeedDome ® Ultra Outdoor Housing Installation Guide–Continuation ADSDUHOC ADSDUHOS ADSDUHOVRC ADSDUHOVRS Contents: To the Installer....................................................... 3 About the Produ...

Page 4 - Warnings and Cautions; Warnings; North America power requirements:; Cautions; Lightning Protection Reference

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 4 of 12 Warnings and Cautions Please review the following warnings and cautions before you begin installation or service. Warnings WARNING! Always use proper lift and safety equipment for the location and type of ...

Page 5 - Preventing Condensation; Exploded view

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 5 of 12 Preventing Condensation Damage, missing parts, or procedures that most often allow water to enter the housing are as follows (refer to figures opposite): Missing O-ring on cover, or missing sleeve or sea...

Page 6 - Connector Pin Assignments; Manchester; Cable Requirements; Data Cable; Data cable requirements; Power Cable

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 6 of 12 Connector Pin Assignments GREEN CONNECTOR (POWER) Pin Color Description 1 Black 24Vac 2 Red Common 3 White 24Vac BLACK CONNECTOR (DATA) Manchester Pin Color* Designation 1-4 — Not used. 5 White/Orange Manc...

Page 7 - Leave the dome camera set; Unterminating the Outdoor Housing; TB5 Pin Designations

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 7 of 12 Housing Termination and Video Configuration Both the outdoor housing and dome camera are shipped “terminated” for when they are installed at the end of a data cable. Should the cable continue to another do...

Page 8 - Keep the cover and use it to protect

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 8 of 12 4. On the circuit board is a mark (shown below). To reattach the board to the housing, match the mark to an identical mark on the base and snap the board in place. 5. Gently remove the dust cover. Note: Ke...

Page 9 - Troubleshooting; Dome Does Not Respond to Commands; Connector P7 pin outs

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 9 of 12 Troubleshooting This section covers what to do when: • Dome does not respond to commands • Fans do not turn • Picture is grainy or discolored • Poor video • Ice forms on bubble. CAUTION: Some steps in this...

Page 10 - SensorNet Data Connections; Blowers Do Not Turn

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 10 of 12 SensorNet Data Connections Pin Color Designation 1-4 — Not used. 5 White/Orange SensorNet (unshielded) 6 White/Yellow SensorNet (unshielded) 4. Check fans. Are they on? - YES: Continue. - NO: Go to “Fans ...

Page 11 - Ice Forms On Bubble; Specifications; Environmental

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 11 of 12 Ice Forms On Bubble Follow steps until the problem is corrected. See page 5 to order parts. 1. Are blower/heater fans in the housing working? If not, see “Fans Do Not Turn” opposite. 2. Is the camera dome...

Page 12 - Declarations; Regulatory Compliance; Other Declarations

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C INSTALLATION GUIDE - CONTINUATION 12 of 12 Declarations Regulatory Compliance REG ID: SV SDUO Emissions .............................. 47 CFR, Part 15, Class A ICES-003 CISPR 22, Class A Immunity ......................................................