American Audio V1500 - Manuals

Page 2 - CAUTION; risk of electric shock

C O N T E N T S FRONT PANEL............................................................................................................................................................4 REAR PANEL............................................................................................................

Page 4 - FRONT PANEL; Do Not Block These

FRONT PANEL 1. Channel 1 Signal indicator - This Green LED will glow when there is an input signal present. 2. Channel 1 Protect indicator - This red LED will glow when channel one goes in to protect mode. In protect mode the output signal to the speakers will terminated to channel one. 3. Channel 1...

Page 5 - REAR PANEL; This may reduce the buzz that is caused

REAR PANEL 6 5 4 3 2 1 7 8 9 1. Channel 1 Input - Connect the input source for channel one to either the balance XLR or the unbalanced 1/4” input jacks. 1/4” TS plug - Tip is positive, Sleeve is negative. XLR - Pin three positive, Pin two is negative, Pin one is ground. See the chart on page 6. 2. C...

Page 6 - INPUTS; input of another amp.; XLR Pin Configuration:; US ITT Standard; GROUND

INPUTS The V1500™ allows you two types of input connector per a channel, a XLR jack for balanced connections and a 1/4” jack for unbalanced connections. Use these connection to connect the output signal from a mixer, cross-over or EQ to your V1500 amplifier. The XLR connection is recommended for cab...

Page 7 - Although; Mono Bridge Connections:; See page 8 Diagram 8

© American DJ Supply ® - www.americandj.com - V1500™ Power Amplifier Instructions page 7 OUTPUTS: Connect your speakers to the binding post outputs in the rear of the amp. The speaker wire may be connect by bare wire (directly connected usually for permanent connections), banana plug, or spade conne...

Page 8 - TYPICAL MONO BRIDGE SET-UP; OHM MINIMUM; SPEAKERS; OHM MINIMUM; SPEAKERS; OHM MINIMUM

TYPICAL MONO BRIDGE SET-UP SPEAKERS 8 OHM MINIMUM Typical Stereo Output Connections V1500™ Power Amplifier Instructions page 8 Diagram 8 Diagram 7 SPEAKERS 4 OHM MINIMUM SPEAKERS 4 OHM MINIMUM

Page 9 - Typical Stereo Set-Up; Typical Mixer

Typical Stereo Set-Up Typical Mixer V1500™ (Rear View) Typical Speaker Connect to V1500™ Channel One Output Typical Speaker Connect to V1500™ Channel Two Output V1500™ Power Amplifier Instructions page 9 Diagram 9

Page 10 - MONO BRIDGE OPERATION:; one gain to regulate your amplifier output.; LIMITER; the amplifier cools down.; INPUT/OUTPUT PROTECTION; from the output and helps keep the amplifier

NORMAL OPERATION: Page 9/Diagram9 show you an example of a typical stereo set-up. Connect your inputs into channels one and two of the amplifier. Connect your speakers to the outputs on the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level (full count...

Page 11 - SPECIFICA TIONS

V1500™ Power Amplifier Instructions page 11 Output Power: 2 ohms, 1 khz 1% THD 4 ohms, 1khz, 1% THD 8 ohms, 1khz 1% THD (Bridge Mode, mono) 4 ohms, 1khz, 1% THD 8 ohms, 1khz, 1% THD Dimensions & Weight: Height Width Depth WeightFrequency Response: +/- 1db, 1w RMS. 8 ohms +/- 0.2 db, @ rated outp...