American Audio V1500 - Manual
American Audio V1500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CAUTION; risk of electric shock
- Page 4 – FRONT PANEL; Do Not Block These
- Page 5 – REAR PANEL; This may reduce the buzz that is caused
- Page 6 – INPUTS; input of another amp.; XLR Pin Configuration:; US ITT Standard; GROUND
- Page 7 – Although; Mono Bridge Connections:; See page 8 Diagram 8
- Page 8 – TYPICAL MONO BRIDGE SET-UP; OHM MINIMUM; SPEAKERS; OHM MINIMUM; SPEAKERS; OHM MINIMUM
- Page 9 – Typical Stereo Set-Up; Typical Mixer
- Page 10 – MONO BRIDGE OPERATION:; one gain to regulate your amplifier output.; LIMITER; the amplifier cools down.; INPUT/OUTPUT PROTECTION; from the output and helps keep the amplifier
- Page 11 – SPECIFICA TIONS
User Instructions
American Audio
®
American Audio
®
4295 Charter Strret
Los Angeles Ca. 90058
Revised 5/01
™
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
C O N T E N T S FRONT PANEL............................................................................................................................................................4 REAR PANEL............................................................................................................
FRONT PANEL 1. Channel 1 Signal indicator - This Green LED will glow when there is an input signal present. 2. Channel 1 Protect indicator - This red LED will glow when channel one goes in to protect mode. In protect mode the output signal to the speakers will terminated to channel one. 3. Channel 1...
REAR PANEL 6 5 4 3 2 1 7 8 9 1. Channel 1 Input - Connect the input source for channel one to either the balance XLR or the unbalanced 1/4” input jacks. 1/4” TS plug - Tip is positive, Sleeve is negative. XLR - Pin three positive, Pin two is negative, Pin one is ground. See the chart on page 6. 2. C...
