Amana PTC153E25AXXXAA- Manuals

5 Select one of the three slots that places the magnet ½” from the sensor mounting plate on the door frame. See expamples below. The door frame and door usually will not align. Place holder on the door and select the slot that places the magnet as close as possible to the ½” depth from the back of t...

6 2. Press and then immediately release the white tactilebutton on the back of the DS01* thermostat. should now be displayed on the PTAC LED display. If does not show on the display in 1-2 seconds, then press andrelease the white button a second time. Skip this step ifthere is no thermostat. 3. Pres...

7 Configuration Settings The PTAC control will automatically self-configure to work with the wall thermostat (DS01* Kit) if installed. The PTACcontrol will automatically self-configure to activate pre-configured energy management routine when the DD01* isinstalled and bound to the PTAC. Additionally...

8 Setback Temps - DD01* The DD01* and the DigiSmart control can be programmed for 3 different times to activate temperature setbacks. Thecurrent factory default temperature setbacks in v2.5 * software release are: 2º from set point in 30 minutes, 3º in one (1)hour, and 6º in three (3) hours. For eac...

10 PTAC MOTION SENSOR OUTSIDE PTAC MOTION SENSOR OUTSIDE Typical Room Layouts NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protectionagainst harmful interfer...