Amana PTC153E25AXXXAA- User Manual
Amana PTC153E25AXXXAA– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FRONT MOUNTING; Wire; top; Thermostat Installation for DS01* Kit; Skip these steps if not installing.
- Page 3 – See Binding Instructions on page 5.; Mounting Sensor/Door Magnet Installation for
- Page 4 – Door Magnet Installation; MAGNET HOLDER TOP
- Page 5 – POSITION A; POSITION C; POSITION B; RECTANGULAR INDENTATION
- Page 6 – Binding of RF Devices; DO NOT ATTEMPT TO BIND; All must be bound at one time.
- Page 7 – If; Entering Room Number (Skip if not using DP01* Front Desk Platform); HEAT
- Page 8 – WARNING
- Page 10 – Typical Room Layouts; C A U T I O N
- Page 11 – THIS PAGE INTENTIONALLY LEFT BLANK
PTAC
WIRELESS KITS (DT01*, DS01*, DD01*)
I
NSTALLATION
I
NSTRUCTIONS
November 2007
IO-644D
The following installation instructions are for a typical installation.
Please contact your PTAC salesperson
for additional assistance and explanation prior to ordering materials or cutting openings.
USE ONLY ONE DD01* PASSIVE INFRARED MOTION SENSOR (PIR) DOOR SWITCH
COMBINATION DEVICE AND/OR ONE DS01* TO ONE DIGISMART PTAC UNIT.
DS01*
DD01*
DT01*
AIR CONDITIONING SENSOR
®
is a trademark of Maytag Corporation and is used
under license to Goodman Company, L.P. All rights reserved.
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the product better than the customer.
This includes all safety precautions and related items.
Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual.
Pay special attention to all safety warnings. Often during installation or repair
it is possible to place yourself in a position which is more hazardous than when the unit is in operation.
Remember, it is
your
responsibility to install the product safely and to know it well enough
to be able to instruct a customer in its safe use.
Safety is a matter of common sense...a matter of thinking before acting.
Most dealers have a list of specific good safety practices...follow them.
The precautions listed in this Installation Manual are intended as supplemental to existing practices.
However, if there is a direct conflict between existing practices and the content of this manual,
the precautions listed here take precedence.
IO-644C~IO-644C~092007~4
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Antenna Installation For DT01* Kit A DT01* antenna must be installed to the PTAC to allowoperation of either the DS01* remote RF thermostat or aDD01* combination PIR motion sensor and door switch. Preparation 1. Disconnect power to the unit by unplugging the powercord at the wall outlet or subbase...
3 .2. Remove thermostat from mounting plate by pulling apart. 3. Place thermostat mounting plate against the wall at de-sired location and mark placement of mounting holes. 4. If mounting in drywall, tap plastic anchors into wall. Forother surfaces, drill a 3/16” hole. 5. Screw mounting plate to the...
4 Door Magnet Installation Mount the door magnet holder on the front of the door where it will be as close as possible to the bottom of the motionsensor but no more then 1/8" from the bottom center of the motion sensor (DD01*) when the door is closed. Select the correct slot in the magnet holder...
