Allied Telesis Patch 89262-08 - Manuals

Allied Telesis Patch 89262-08 – Manual in PDF format online.

Manuals:

Manual

Manual Allied Telesis Patch 89262-08

Summary

Page 2 - Level 1

2 Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H Some of the issues addressed in this Release Note include a level number. This number reflects the importance of the issue that has been resolved. The levels are: From Patch 89262-07 onwards, issues for each patch are...

Page 3 - Level 3

Patch 89262-08 For AT-8900 Series Switches 3 Patch 89262-08 for Software Release 2.6.2C613-10402-00 REV H When STP is enabled, when frames with a multicast destination MAC address were sent, a loop was observed within the network. This issue has been resolved. In network configurations with multiple...

Page 4 - Level 4; Level: 3; Level: 2

4 Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H Fixing speed on a fibre SPF to 1000mfull in a configuration script showed up incorrectly as 10mfull actual speed after reboot. This issue has been resolved. Level 4 No issues. Enhancements No issues. Features in 89262...

Page 10 - show tacplus

10 Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H When a virtual link end point is no longer reachable, the virtual interface is not brought down, and the virtual neighbour is not removed. This issue has been resolved. Setting switch enhanced mode to “none” in order...

Page 18 - add qos port

18 Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H The IPv6 Accelerator Card port (port 53) can only be associated with a QOS policy containing classifiers that specify ethii-tagged as the Ethernet encapsulation and IPv6 as the protocol: create classifier= rule-id et...

Page 23 - Command Reference; show ip igmp; Syntax; Description

Patch 89262-08 For AT-8900 Series Switches show ip igmp 23 Patch 89262-08 for Software Release 2.6.2C613-10402-00 REV H IGMP Snooping All-Group Entry Because IGMP is an IP-based protocol, multicast group membership for VLAN aware devices is on a per-VLAN basis. If at least one port in the VLAN is a ...

Page 24 - Examples; See Also; enable ip igmp allgroup

24 enable ip igmp allgroup Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H Figure 1: Example output from the show ip igmp command. Examples To show information about IGMP, use the command: SHOW IP IGMP See Also ENABLE IP IGMP ALLGROUPDISABLE IP IGMP ALLGROUP enable i...

Page 25 - disable ip igmp allgroup

Patch 89262-08 For AT-8900 Series Switches disable ip igmp allgroup 25 Patch 89262-08 for Software Release 2.6.2C613-10402-00 REV H The ALLGROUP parameter specifies the list of ports able to behave as all-group entry ports. If ALL is specified, all ports are able to behave as all-group entry ports. ...

Page 26 - add igmpsnooping routeraddress

26 add igmpsnooping routeraddress Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H ■ RIP2 routers, 224.0.0.9 ■ All PIM routers, 224.0.0.13 ■ All CBT routers, 224.0.0.15 If IP is specified, addresses treated as router multicast addresses are specified by the user using...

Page 27 - set igmpsnooping routermode; delete igmpsnooping routeraddress

Patch 89262-08 For AT-8900 Series Switches delete igmpsnooping routeraddress 27 Patch 89262-08 for Software Release 2.6.2C613-10402-00 REV H set igmpsnooping routermode Syntax SET IGMPSNOOPING ROUTERMODE= {ALL|DEFAULT|IP|MULTICASTROUTER|NONE} Description This command sets the mode of operation for I...

Page 28 - show igmpsnooping routeraddress; ICMP Redirect Messages for IPv6

28 show igmpsnooping routeraddress Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H show igmpsnooping routeraddress Syntax SHOW IGMPSNOOPING ROUTERADDRESS Description This command displays information about the list of configured IP multicast router addresses currentl...

Page 29 - Importing BGP routes into OSPF

Patch 89262-08 For AT-8900 Series Switches show igmpsnooping routeraddress 29 Patch 89262-08 for Software Release 2.6.2C613-10402-00 REV H Importing BGP routes into OSPF Introduction With this enhancement you can import routes from BGP into OSPF. OSPF will then redistribute these routes. This enhanc...

Page 30 - set ospf

30 set ospf Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H Configuration example This example supposes that you want to import the route 192.168.72.0 into the OSPF routing domain, but no other routes. This route is received on the gateway router as a BGP route. The ...

Page 31 - show ospf

Patch 89262-08 For AT-8900 Series Switches show ospf 31 Patch 89262-08 for Software Release 2.6.2C613-10402-00 REV H show ospf Syntax SHow OSPF Description This command displays information about the general configuration of OSPF routing (Figure 3 on page 31, Table 11 on page 31). New entries for th...

Page 32 - add ip filter; Availability

32 add ip filter Patch Release Note Patch 89262-08 for Software Release 2.6.2 C613-10402-00 REV H add ip filter Syntax ADD IP FILter= filter-number {ACTion=INCLude|EXCLude} SOurce= ipadd [SMask= ipadd ] [ENTry= entry-number ] [ other- parameters ] Description This command adds a pattern to a routing...