AEG W14120 - Manuals

hazardous to children. Do not allow children to play with the packaging or small parts from the Washing Machine. • Keep the packaging materials in a place where children cannot reach them, or dispose of them appropriately. • Use pre-wash programs only for very dirty laundry. Never open the detergent...

electric shock. • Do not touch your Washing Machine if your hands or feet are wet. • A damaged power cord/plug can cause fire or give you an electric shock. When damaged it must be replaced, this should only be done by qualified personnel. Risk of flooding • Check the speed of water flow before plac...

or on its side. • Do not lift your Washing Machine using the door or detergent drawer. The machine must be carried by at least 2 people. Child safety • Do not leave children unattended near the machine. Children might lock themselves in the machine resulting in risk of death. • Do not allow children...

reduces raw material consumption and decreases waste production. 1.4 ENERGY SAVING INFORMATION Some important information to get the most efficient use out of your machine: • Do not exceed the maximum load for the washing programme you have chosen. This will allow your machine to run in energy savin...

EN - 11 EN - 11 2. TECHNICAL SPECIFICATIONS 1 2 3 4 5 6 7 89 10 2.1 General Appearance 1. Electronic Display 2. Programme Dial 3. Upper Tray 4. Detergent Drawer 5. Drum 6. Pump Filter Cover 7. Water Inlet Valve 8. Power Cable 9. Discharging Hose 10. Transit Bolts 2.2 Technical Specifications Operati...

EN - 12 EN - 12 3. INSTALLATION 3.1 Removing the Transit Bolts X X 4 4 X 4 1 3 2 4 1. Before operating the washing machine, remove the 4 transit bolts and rubber spacers from the rear of the machine. If the bolts are not removed, they will cause heavy vibration, noise and malfunction of the machine ...

EN - 13 EN - 13 • The mains cord of your washing machine is equipped with a grounded plug. This plug should always be inserted into a grounded 15 amp receptacle. • If connected to a circuit protected by fuses, use time-delay fuses with this appliance. • If you do not have a suitable receptacle and f...

EN - 14 EN - 14 the red water inlet valve (if applicable). • Hand tighten the connections. If in any doubt, consult a qualified plumber. • Water flow with pressure of 1-10 Bar or 0. 1-1 Mpa will allow your machine to operate at optimum efficiency (pressure of 1 Bar or 0. 1 Mpa means that more than 8...

EN - 15 EN - 15 5.1 Detergent Drawer 1 2 3 4 5 6 1. Liquid Detergent Attachments 2. Main Wash Detergent Compartment 3. Softener Compartment 4. Pre-Wash Detergent Compartment 5. Powder Detergent Levels 6. Powder Detergent Scoop (*) (*) Specifications may vary depending on the machine purchased. 5.2 S...

EN - 16 EN - 16 5.3 Program Dial • To select the desired programme, turn the programme dial either clockwise or anti-clockwise until the marker on the programme dial points to the chosen programme. • Make sure that the programme dial is set exactly to the programme you want. 5.4 Electronic Display 9...

EN - 17 EN - 17 or bag. 6. Reverse textiles such as pants, knitwear, t-shirts and sweat shirts. 7. Wash socks, handkerchiefs and other small items in a washing net. Maximum ironing temperature 150°C / 302°F Cn be dry cleaned Drip dry Dry cleaning in gas oil, pure alcohol and R113 is allowed Maximum ...

EN - 24 EN - 24 8. USER- MAINTENANCE INSTRUCTIONS 8.1 Warning To reduce the risk of electric shock, disconnect this appliance from the power supply before attempting any user maintenance. Turning the controls to the OFF position does not disconnect this appliance from the power supply. Turn your mai...

EN - 25 EN - 25 • Clean the filter thoroughly with a soft brush and wash with soapy water and rinse thoroughly. Re-insert the filter by gently pushing it back into place. CAUTION: The filters at the water inlet valve may become clogged due to water quality or lack of required maintenance and may bre...

EN - 26 EN - 26 • Remove the detergent drawer and disassemble the flush stopper. Clean thoroughly to completely remove any softener residue. Refit the flush stopper after cleaning and check that it is seated properly. • Rinse with a brush and lots of water. • Collect the residue inside the detergent...

EN - 28 FAULT POSSIBLE CAUSE TROUBLESHOOTING Unsatisfactory washing result. Hard water. Increase the amount of detergent following the manufacturer’s instructions. Your laundry is too tightly packed together in the drum. Check that your laundry is spread out. As soon as the machine is loaded with wa...