AEG LF8516O8O - User Manual

• The appliance maximum load is 10.0 kg. Do not exceed the maximum load of each program (refer to the “Programs” chapter). • The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 10 bar (1.0 MPa). • The ventilation opening in the base...

2.6 Service • To repair the appliance contact the Authorised Service Centre. Use original spare parts only. • Please note that self-repair or non- professional repair can have safety consequences and might void the guarantee. • Concerning the lamp(s) inside this product and spare part lamps sold sep...

3.2 Appliance overview 1 2 3 10 6 7 8 4 11 9 12 13 5 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Internal light 6 Rating plate 7 Drain pump filter 8 Feet for levelling the appliance 9 Drain hose 10 Inlet hose connection 11 Mains cable 12 Transit bolts 13 Hose support 00000000 00A...

5. Carefully put the appliance down on its rear side. 6. Put the front polystyrene packaging element on the floor under the appliance. Make sure not to damage the hoses. 7. Remove the polystyrene protection from the bottom. 1 2 8. Pull up the appliance in vertical position. 9. Remove the power suppl...

The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm - min. 1.5") must be larger than the external diameter of the drain hose. 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5...

6. CONTROL PANEL 6.1 Control panel description 3s Finish In Re m ote Star t O n/O ff Stain s/ Prewa sh Tim e S ave E x tra Rin s e Plu s Steam Temperature Spin Sports Home Special 4 5 3 2 7 8 6 15 14 12 11 10 13 1 9 The options are not selectable with all washing programs. Check the compatibility be...

You must drain the water to unlock the door. Touch the Start / Pause button: the appliance performs only the draining phase. • No Spin . Set this option to deactivate all spin phases. The display shows theindicator . The appliance performs the only draining phase of the selected washing program. Set...

display shows the text Hr for 2 seconds, 12 (thousands and hundreds) for 2 seconds and 76 (tens and units). 4. To exit this mode, press any button or switch the appliance off by means of theOn/Off button. If the procedure does not work (due to timeout or wrong keys combination), switch the appliance...

DO NOT set this mode with the following type of items: • Items that are not suitable for tumble drying. • Items with label "Dry clean only". Do not use any detergent! The Steam programs do not remove particularly intense odour and do not perform any hygienic cycle. After the steam treatment ...

Program Universal powder 1) Liquid Uni‐ versal Liquid for coloureds Delicates woollens Special Synthetics ▲ ▲ ▲ -- -- Delicates -- -- -- ▲ ▲ Wool -- -- -- ▲ ▲ 20min 3kg -- ▲ ▲ -- -- Bed l inen XL -- -- -- ▲ ▲ Hygiene ▲ ▲ -- -- ▲ 1) At temperature higher than 60 °C the use of powder detergent is reco...

11.6 Wi-Fi Always On The Wi-Fi Always On function is available in the App.This function keeps the appliance connected to the network even when the appliance is turned off.The indicator goes on and off intermittently (1 second on , 5 seconds off). It is possible to turn the appliance on by pressing t...

12.3 Filling the detergent and additives - Compartment for detergent pods (Max 2 pods). When using detergent tab‐ lets, make sure that the Pods® option is activated. - Compartment for prewash phase an soak program (powder detergent only). - Compartment for washing phase (powder detergent only). Make...

c) Put the tablets in the compartment . Make sure that the Pods® option is activated. 4. Pour fabric softener in the compartment . 5. Close the detergent dispenser. 12.4 Setting a program 1. Turn the program dial to select the desired washing program. The related program indicator comes on. The indi...

3. Set the program again. 12.7 The ProSense load detection The program duration in the display is referred to a medium/high load. After setting a washing program, the icon lights up on the display if the program supports it. After touching the Start / Pause button, the ProSense starts the laundry lo...

2. Change the options. The given information in the display changes accordingly. 3. Touch the Start / Pause button again. The washing program continues. 12.10 Cancelling a running program 1. Press the On/Off button to cancel the program and to deactivate the appliance. 2. Press the On/Off button aga...

• The display shows the indicator , the option indicator or and the door locked indicator . The indicator of the running phase flashes. • The drum still turns at regular intervals to prevent the creases in the laundry. • The door stays locked. • You must drain the water to open the door: 1. If neces...

b. manually redistribute the load so that the items are spaced evenly around the tub; c. press the Start / Pause button. The spin phase continues. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts, cords, shoelaces, ribbons and any other loose elements. • Do not wash laundry wi...

Excessive detergent may cause: • sudsing, • reduced washing effect, • inadequate rinsing, • a greater impact for the environment. 13.4 Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips:• Normally soiled laundry may be washed without p...

14.3 External cleaning Clean the appliance with mild soap and warm water only. Fully dry all the surfaces.Do not use a scouring pads or any scratching material. CAUTION! Do not use alcohol, solvents or chemical products. CAUTION! Do not clean the metal surfaces with chlorine-based detergent. 14.4 De...

Do not use any detergent. 3. Run a cotton program with the highest temperature without detergent. If your appliance can be connected to Wi-Fi, the special program Machine Clean is also downloadable through the APP. 14.8 Cleaning the detergent dispenser To prevent possible deposits of dried detergent...

7. Make sure that all detergent residue is removed from the conveyor. Use only soft damp clothes. 8. Put bottom cover back to its position by aligning its holes on drawer hooks as indicated in the picture. Close it till "click" sound. CAUTION! Press the bottom cover as indicated in the pictu...

• The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code . WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to...

45° 20° 14.11 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain pump' paragraph. If necessary, clean the pump.When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres o...

Problem Possible solution The appliance makes an unusual noise and vibrates. • Make sure the levelling of the appliance is correct. Refer to "Installation instruction". • Make sure that the packaging and/or the transit bolts are re‐ moved. Refer to "Installation instruction". • Add m...

16.2 Cleaning the drain pump filter 1 3 2 180˚ 2 1 Clean the filter regularly and, especially,if the alarm code appears on the display. 16.3 Programs Programs Load Product description PowerClean 59min 5.0 kg Cotton and synthetic items. This program ensures a good washing performance in a short time....

of Goods Act and the Fair Trading Act. Where the Appliance was purchased in New Zealand for commercial purposes the Consumer Guarantee Act does not apply. 11. Confidentiality: You accept that if you make a warranty claim, Electrolux and its agents including ASC may exchange information in relation t...