AEG 10694 - Manuals

MSO Upgrade Kit Instructions Page 2 of 5 Installation Precautions: 1. Disconnect power source to completely remove power from device before attempting to perform the steps outlined in this procedure. 2. This product contains ESD sensitive devices. Use of proper ESD handling practices (such as anti-s...

MSO Upgrade Kit Instructions Page 3 of 5 3. Locate and remove with a #2 Phillips Screwdriver the 3 ea. 6-32 x 5/8” Screws MOI PN 601580 and #6 Star Washers MOI PN 602260 from the Circuit Board MOI PN 10460-3. See Figure 4. Figure 4 4. Push the shield wire out of the way and carefully lift the PCB st...

MSO Upgrade Kit Instructions Page 4 of 5 5. Remove and discard both rubber grommets and old temp-RH sensor. Figure 6 Note: Be aware that it is possible that the surface of the Temp-RH Sensor Assy. Grommet may stick to the surface of the PCB Housing Grommet causing the Temp-RH Sensor to separate from...

viii Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide OL-10694-01 Preface Conventions Conventions This document uses these conventions and symbols for notes, cautions, and warnings: Note Means reader take note. Notes contain helpful suggestions or references to materials not cont...

ix Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide OL-10694-01 Preface Obtaining Documentation • These compatibility matrix documents are available from this Cisco.com site: http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_tables_list.html – Cisco Gi...

x Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide OL-10694-01 Preface Documentation Feedback Ordering Documentation You must be a registered Cisco.com user to access Cisco Marketplace. Registered users may orderCisco documentation at the Product Documentation Store at this URL: ...

HOBO Pro v2 2 Cables U23-001: No cables U23-002: One 184 cm (6 ft.) PVC cable; sensor diameter 1 cm (0.38 in.) U23-003: Two 184 cm (6 ft.) PVC cables; sensor diameter 0.5 cm (0.20 in.) U23-004: One 184 cm (6 ft.) PVC cable; sensor diameter 0.5 cm (0.20 in.) Environmental rating Electronics housing i...

HOBO Pro v2 3 Deploying and protecting the logger • To clean the logger’s case, use a sponge with warm, soapy water. • Use the included clamp to mount the logger to a surface. The clamp has two holes for the screws, 44 mm (1.7 inches) apart. The clamp is slightly tapered to accommodate the logger. I...

HOBO Pro v2 4 Circuit board Protective cap Battery Desiccant packs Cable from sensor (if applicable) Grommet for cable (if applicable) 4. Install a new 1/2 AA, 3.6 Volt lithium battery (part # HP-B). The positive end of the battery should face towards the communication LEDs. 5. Use a clean, dry clot...