AEG 10694 - Manual
AEG 10694 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MSO Upgrade Kit Instructions; Installation Precautions:; attempting to perform the steps outlined in this procedure.; Disassembly; Figure 2; misshape the dome of the Moisture Shield. See Figure 3.; Figure 3
- Page 3 – Figure 4; Remove
- Page 4 – Figure 6; Reassembly
- Page 5 – Figure 7; J3 Connector
MSO Upgrade Kit Instructions
Page 1 of 5
10694-9800 Rev A
MSO T/RH
Upgrade Instructions
Equipment Required:
1. Phillips Screwdriver size #2
Materials Required:
1. MSO (-232, -485) 5-in-1 Sensor
2. 10694 MSO Temperature-RH Sensor Upgrade kit. See Figure 1.
a. 10697 Temperature-RH Sensor Assembly.
b. 10699 Splash Guard, with #8 Kep nut.
c. This Instruction sheet.
Figure 1
10699 Splash guard
#8 Kep nut
10697 Temperature –RH
Sensor Assembly
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for AEG 10694
Summary
MSO Upgrade Kit Instructions Page 2 of 5 Installation Precautions: 1. Disconnect power source to completely remove power from device before attempting to perform the steps outlined in this procedure. 2. This product contains ESD sensitive devices. Use of proper ESD handling practices (such as anti-s...
MSO Upgrade Kit Instructions Page 3 of 5 3. Locate and remove with a #2 Phillips Screwdriver the 3 ea. 6-32 x 5/8” Screws MOI PN 601580 and #6 Star Washers MOI PN 602260 from the Circuit Board MOI PN 10460-3. See Figure 4. Figure 4 4. Push the shield wire out of the way and carefully lift the PCB st...
MSO Upgrade Kit Instructions Page 4 of 5 5. Remove and discard both rubber grommets and old temp-RH sensor. Figure 6 Note: Be aware that it is possible that the surface of the Temp-RH Sensor Assy. Grommet may stick to the surface of the PCB Housing Grommet causing the Temp-RH Sensor to separate from...
