ADTRAN 1109403L2 - Manuals - manualsarea.com

Page 2 - Features; -law encoding and decoding; Compliance; shows the compliance codes for the FXS/DPO.; CAUTION; Code; C A U T I O N !

2 Issue 2, December 2004 61180403L1-5B • PLAR D3• Tandem • DPO• FX Ringdown• TO w/Sealing Code Features The basic features of the FXS/DPO include the following: • µ -law encoding and decoding • Supports ground start, loop start, PLAR, DPO, and Tandem, TR08SP, TR08UVG, TR08AUTO, and FX Ringdown • Sup...

Page 3 - Table 3; Table 2. Front Panel LEDs and Switch; BUSY

61180403L1-5B Issue 2, December 2004 3 Instructions for Installing the Module To install the FXS/DPO, perform the following steps: 1. If present, remove the Access Module Blank (P/N 1175099L1) from the appropriate access module slot of the Total Access chassis. 2. Pull the ejector latch, located on ...

Page 4 - Hardware Provisioning; DIP switches; Table 4; on; Figure 2; on page 6 provides a graphic detail; NOTE

4 Issue 2, December 2004 61180403L1-5B Hardware Provisioning DIP switches SW1 , SW2 , SW3 , and SW4 are used to provision many of the FXS/DPO options. Table 4 on page 5 summarizes the options provisioned by the DIP switches. Figure 2 on page 6 provides a graphic detail of the four switches and the p...

Page 5 - Table 4. DIP Switches; Label

61180403L1-5B Issue 2, December 2004 5 Table 4. DIP Switches Sw.-Segment Label Function/Description 1-1 D3/D4 D3 or D4 Signaling (PLAR only) 1-21-3 MODE 1/OFFMODE 2/OFF SW1-2 SW1-3 Mode Selected OFF OFF FXS OFF MODE 2 DPO MODE 1 OFF Tandem MODE 1 MODE 2 PLAR 1-4 GS/LS Ground Start or Loop Start 1-5 ...

Page 6 - ADMIN; Table 5; FXS/DPO General Options; Table 6; FXS/DPO Tandem Options; Password and User ID; Logon; Menu Navigation; Figure 3

6 Issue 2, December 2004 61180403L1-5B Figure 2. DIP Switches Detail Software Provisioning The FXS/DPO is provisioned by connecting a VT100 terminal or a computer running a terminal emulation program to the craft interface ADMIN port located on the System Controller Unit (SCU) front panel. Connectio...

Page 7 - Busy in CFA; Table 7; Enabled; Defaults are in bold type.; Software Provisioning; on page 6

61180403L1-5B Issue 2, December 2004 7 . Table 5. FXS/DPO General Options Function Option Description Mode Loop Start Ground StartTR08 Single Party (3) TR08 Universal VG (3) TR08 Auto (3) PLAR D4PLAR D3Tandem (3) DPOFX Ringdown (3) TO w/SC (3) This option selects the signaling mode of the FXS/DPO. S...

Page 10 - nu Tree

Figure 3. FXS/DPO Me nu Tree 1. Configuration 2. Provisioning 3. Status 4. Test 1. Digital Network Loopback 2. 1004 Hz Tone Test 2. 2-Wire Termination 1. 600 + 2.16 2. 900 + 2.16 Enter Value (-7.0...+9.0) 3. Transmit TLP 1. Loop Start 3. TR08 Single Party 2. Ground Start 5. TR08 Auto 4. TR08 Univers...

Page 11 - port on the SCU, or remotely via; Digital Network Loopback Test; Warranty and Customer Service; Table 8

61180403L1-5B Issue 2, December 2004 11 4. TEST FEATURES The FXS/DPO supports the following tests for each port: • Digital Network Loopback• 1004 Hz Tone Generation• Network Hook Test• Customer Ringing Test These test are used to support circuit turn-up and maintenance efforts. Test functions can be...

Page 12 - Table 8. Specifications; Total Access 1500 Foreign Exchange Station/Dial

12 Issue 2, December 2004 61180403L1-5B Table 8. Specifications Performance Loop Current: Transmit TLP: Receive TLP: Terminating Impedance: Return Loss: TransHybrid Loss: Longitudinal Balance: Frequency Response: Idle Channel Noise: PCM Encoding/Decoding: DC Supervisory Range: 23 mAmp nominal20 mAmp...