Page 3 - iii; Special notes on LCD monitors; Safety instructions; Cleaning your monitor; Connecting/disconnecting the device
iii Special notes on LCD monitors The following are normal with the LCD monitor and do not indicate a problem. • Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the power switch and then turn it on again to make sure the flicker disappears. • You may f...
Page 4 - iv; Accessibility; Warnings; Using electrical power
iv Accessibility Be sure that the power outlet you plug the power cord into is easily accessible and located as close to the equipment operator as possible. When you need to disconnect power from the equipment, be sure to unplug the power cord from the electrical outlet. Safe listening To protect yo...
Page 5 - Product servicing
v ampere rating of the equipment plugged into the extension cord does not exceed the extension cord ampere rating. Also, make sure that the total rating of all products plugged into the wall outlet does not exceed the fuse rating. • Do not overload a power outlet, strip or receptacle by plugging in ...
Page 6 - Potentially explosive environments; Additional safety information
vi Note: Adjust only those controls that are covered by the operating instructions, since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal condition. Potentially explosive environments Switch o...
Page 7 - vii; Disposal instructions; Warning Message for Magnet
vii Disposal instructions Do not throw this electronic device into the trash when discarding. To minimize pollution and ensure utmost protection of the global environment, please recycle. For more information on the Waste from Electrical and Electronics Equipment (WEEE) regulations, visit LCD pixel ...
Page 8 - viii; Tips and information for comfortable use; Finding your comfort zone
viii This product has been shipped enabled for power management: • Activate display’s Sleep mode within 15 minutes of user inactivity. • Activate computer’s Sleep mode within 30 minutes of user inactivity. • Wake the computer from Sleep mode by pushing the power button. Tips and information for comf...
Page 9 - ix; Taking care of your vision
ix Taking care of your vision Long viewing hours, wearing incorrect glasses or contact lenses, glare, excessive room lighting, poorly focused screens, very small typefaces and low-contrast displays could stress your eyes. The following sections provide suggestions on how to reduce eyestrain.Eyes • R...
Page 11 - Federal Communications Commission; HK
Acer America Corporation 333 West San Carlos St., Suite 1500 San Jose, CA 95110, U. S. A. Tel : 254-298-4000 Fax : 254-298-4147 www.acer.com Federal Communications Commission Declaration of Conformity This device com plies with Part 15 of the FCC Rules. Operation is subject to the following two cond...
Page 13 - Unpacking
1 Eng lis h Unpacking Please check that the following items are present when you unpack the box, and save the packing materials in case you need to ship or transport the monitor in the future. LCD monitor Quick start guide DVI cable (Option) AC power cord Audio Cable (Option) (Option) DP cable (Opti...
Page 14 - Engli
2 ATTACHING/REMOVING THE BASE ATTACHING/REMOVING THE BASE ATTACHING/REMOVING THE BASE ATTACHING/REMOVING THE BASE ATTACHING/REMOVING THE BASE Install: Align the base with the stand and push the base towards the top ofthe monitor, and then rotate the base clockwise. Tighten the screw clock-wise. Remo...
Page 15 - lis; mm
3 SCREEN POSITION ADJUSTMENT SCREEN POSITION ADJUSTMENT SCREEN POSITION ADJUSTMENT SCREEN POSITION ADJUSTMENT SCREEN POSITION ADJUSTMENT In oder to optimize the best viewing position, you can adjust the height/tilt/swivel/pivot of the monitor. ••• t l i T t l i TT i l t T i l t T i l t Please see th...
Page 16 - SS w i v e l; Englis
4 ••• l e v i w S l e v i w S l e v i w S l e v i w SS w i v e l With the built-in pedestal, you can swivel the monitor for the mostcomfortable viewing angle. Englis h o 60 60
Page 17 - Connecting the power cord
5 Eng lis h Connecting the power cord • Check first to make sure that the power cord you use is the correct type required for your area. • The monitor has a universal power supply that allows operation in either 100/120 V AC or 220/240 V AC voltage area. No user-adjustment is required. • Plug one en...
Page 18 - English; Connector pin assignment
6 English Connector pin assignment * only for certain models PIN No. Description PIN No. Description 1 TMDS Data2+ 2 TMDS Data2 Shield 3 TMDS Data2– 4 TMDS Data1+ 5 TMDS Data1 Shield 6 TMDS Data1– 7 TMDS Data0+ 8 TMDS Data0 Shield 9 TMDS Data0– 10 TMDS Clock+ 11 TMDS Clock Shield 12 TMDS Clock– 13 C...
Page 21 - Standard timing table
8 English Standard timing table 1 VGA 640x480@60Hz 2 VGA 640x480@72Hz 3 VGA 640x480@75Hz 4 MAC [email protected] 5 VESA 720x400@70Hz 6 SVGA 800x600@56Hz 7 SVGA 800x600@60Hz 8 SVGA 800x600@72Hz 9 SVGA 800x600@75Hz 10 MAC [email protected] 11 XGA 1024x768@60Hz 12 XGA 1024x768@70Hz 13 XGA 1024x768@75Hz 14 ...
Page 22 - Installation; Steps
9 Eng lis h Installation To install the monitor on your host system, please follow the steps below: Steps 1 Connect the video cablea Make sure both the monitor and computer are switched off. (1) Make sure both the monitor and computer are switched off.(2) Connect one end of the 24-pin DVI cable to t...
Page 23 - MENU; OSD functions; INPUT; Input Key; Use the PIP hotkey to active the picture-in-picture function.
EN-13 U S E R C O N T R O L S Power Switch / Power LED: To turn the monitor ON or OFF. Lights up to indicate the power is turned ON. Using the Shortcut Menu Press the function button to open the shortcut menu. The shortcut menu lets youquickly select the most commonly accessed settings. Empowering: ...
Page 24 - Step 1: Press “ “ Key to open the Acer eColor Management OSD and; F ea t u r e s an d Be n e f i t s; “ Key to confirm the mode and exit the eColor menu.; ECO; Adjusts the settings to reduce power
EN-14 M a in M e n u ic o n S u b M e n u ico n Su b Me n u ite m D e scrip tio n N/A User mode User defined. Settings can be fine-tuned to suit any situation N/A N/A Standard mode D e f a u lt S e t t i n g . R e f l e c t s n a t i v e d is p la y capability N/A Grahpic mode Enhances colors and em...
Page 25 - A d j u s t i n g the OSD set t i n g s; Press the MENU key to bring up the OSD.
EN-15 A d j u s t i n g the OSD set t i n g s -------------------------------------------------------------------- Note: The following content is for general reference only. Actualproduct specifications may vary. The OSD can be used for adjusting the settings of your LCD Monitor.Press the MENU key t...
Page 28 - the
EN-17 A d j u s t i n g the setting 1 Press the MENU key to bring up the OSD.2 Using the / keys, select Setting from the OSD. Then navigate to the feature you wish to adjust. 3 The Setting menu can be used to adjust the screen Menu Language and other important settings. 4 Select Power-off USB charge...
Page 30 - Troubleshooting
Troubleshooting Before sending your LCD monitor for servicing, please check the troubleshooting list below to see if you can self-diagnose the problem. DVI / HDMI mode Problem LED status Remedy No picture visible Blue Using the OSD, adjust brightness and contrast to maximum or reset to their default...
