Page 2 - Table of Contents
2 Table of Contents Important Safety Instructions ..............................................................................3 Federal Communications Commission ................................................................4 Connecting the Monitor and Swivel Base ..................................
Page 3 - Important Safety Instructions
3 Important Safety Instructions 1. Please read these instructions thoroughly. 2. Please keep this guide for future use. 3. Please disconnect the device from the main power supply before cleaning. Do not use any liquids or aerosol sprays to clean this device. Use a clean dampened cloth in stead. 4. T...
Page 4 - Federal Communications Commission; Canadian DOC Notice
4 Federal Communications Commission ( FCC Statement ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal...
Page 5 - Connecting the Monitor and Swivel Base; Removing the Monitor and Swivel Base
5 Connecting the Monitor and Swivel Base 1. Place the monitor with its tube down on a stable surface. 2. Align the four tabs of the swivel base with the slots in the bottom of the monitor. 3. Insert the tabs into the slots of the monitor 4. Now slowly slide the swivel base toward the front of the mo...
Page 6 - Introduction; Features
6 Introduction Congratulations on your purchase of this new high performance 15” Monitor. Using state-of-the-art electronics, this monitor supports a 1280 x 1024 resolution. The on-screen display allows you to customize the display settings to suit your individual taste. Features 15-inch monitor wit...
Page 7 - Installation; The installation of your monitor is now complete.
7 Installation 1. Connect the monitor signal cable 1 to the 15-pin mini D-sub (VGA) on the back of the computer. 2. Connect the power cord to the power connector on the back panel of the monitor, then plug the other end into an electrical outlet that is easily accessible, and close to the monitor. 3...
Page 8 - User Controls
8 User Controls Control Function Power Switch Turns the monitor on Green- On Power LED Indicator Amber- Sleep OSD ON/OFF Control Turn the OSD Display ON or OFF Brightness Control/ OSD Function selection Adjust Brightness level or OSD Function selection Control Contrast Control/OSD Function adjustmen...
Page 9 - Adjusting the Brightness and Contrast; OSD Function Description
9 Adjusting the Brightness and Contrast To adjust the contrast and/or brightness, Press the Contrast Control or the Brightness Control , to call up the following on-screen display: OSD Function Description 1. Press the OSD On/Off control button to display the OSD Menu. 2. To select function, press b...
Page 10 - OSD Icon Summary
10 OSD Icon Summary Icon Function Function Description Brightness Adjusts display brightness Contrast Adjusts display contrast H. Size Increases and decreases screen width H. Position Shifts display image right or left V. Size Increase and decrease screen height V. Position Shifts display image up o...
Page 11 - Specification
11 Specification Screen Size 15” CRT Dot Pitch (mm) 0.28 Surface Non –glare Viewable Image Area 260 x 195 Input Signal Video Sync. RGB Analog 0.7Vp-p/75 Ohm Separate H/V,TTL(+/-) Scanning Frequency Horizontal (KHz) 30-70 Vertical (Hz) 50-120 Max. Resolution 1280 x 1024 Signal Cable 15-pin mini D-sub...
Page 12 - Troubleshooting; Problem: Power LED is not lit when monitor is powered on.; Problem: Display image is either flickering or unstable.
12 Troubleshooting Please refer to the following solutions for the failure symptoms that occur the most frequent. If the symptom remains after trying these suggested solutions, please contact your local authorized service center. Problem: Power LED is not lit when monitor is powered on. Check to mak...
Page 13 - note
