3M FSTMO75 - Manuals - manualsarea.com

Page 2 - EXPLANATION OF SIGNAL WORD CONSEQUENCES; WA R N I N G; IMPORTANT NOTES; Water Filtration Products; SAFETY INFORMATION

To reduce the risk associated with property damage due to water leakage: • Read and follow Use Instructions before installation and use of this system. • Before starting installation, shut off main water supply and drain pipes. • Installation and Use MUST comply with all state and local plumbing cod...

Page 3 - tents; Qty; Tank & Bracket Assembly; Figure 1; Product Dimensions

Table of Contents Safety Instructions ................................................................................................................................................................ Page 2 Caution and Warning Statements...................................................................

Page 4 - Mounting; in direct sunlight or outdoors.; Do not install; CAUTION

Mounting 1) Remove the mounting bracket template (see page10) from this manual. Tape it to the wall where the mounting bracket is to be installed. 2) Install mounting screws (not included) into each of the keyhole locations on the template. Be sure to leave a 1/8” to 1/4” space between the bottom of...

Page 5 - Plumbing Connections

To reduce the risk associated with property damage due to water leakage: • Before starting installation, shut off main water supply and drain pipes. • Installation and Use MUST comply with all state and local plumbing codes. • Do not install on hot water supply lines. The maximum operating water tem...

Page 6 - Using Push-In Fittings

6 System Start-Up 1) Remove the prefilter cartridge from its packaging. Remove the red cap from the cartridge and moisten the o-rings with water Insert the cartridge interconnect into the filter head. Be sure that the ears on the cartridge line up with the spaces in the head. Then, turn the cart- ri...

Page 7 - • Tank Pressure should be checked yearly.; Tank Pressure Check; Part Number; Replacement Parts

7 Tools Required: • Piece of 1/4” tubing or Bucket • Bicycle or tire pressure gauge • Bicycle tire pump1) Empty the storage tank. a. Shut off the inlet water valve and Water Booster System if applicable. b. Make sure tank shut-off valve located at the top of the water tank is open. c. Attach a piece...

Page 8 - Troubleshooting Guide

8 Problem Cause Solution Notes Unit Runs Low orOut of Water Low Feed Water Pressure Repair Beverage BoosterPump/System Contact Dealer Add Booster Pump Assembly Only if Beverage Booster System isnot installed RO Membrane Fouled Replace RO Module and SFCTubing (Stealth Flow Control) Feed Water Pressur...

Page 12 - CUNO Incorporated

12 - © 2008 3M Company. All rights reserved. 3M and CUNO are trademarks of 3M Company used under license.INSTR4226 DRAFT CUNO Incorporated 400 Research Park way Meriden, CT 06450, USA Toll Free: 1.888.218.CUNO Worldwide: 203.237.5541 Fax: 203.238.8701 www.cunofoodser vice.com a 3M company Warranty a...