3M 955 - Manuals

Safety 3 Safety In order to be able to use the Model 955 without any problems, kindly observe the section titled General Safety, and take note of any product specific safety instructions in this section. The Model 955 does not have an on/off-switch of its own. The power socket should be easily acces...

Operation 4 Operation Switch the sensitise/desensitise switch to the required operating mode. rat or's Ma nua l Sensitize Desensitize Op e Slide the book through the Model 955 as illustrated adjacent. The light beam from the optical sensor will be interrupted. An audible sensitise/desensitise pulse ...

Operation 4.1 Verification The "Verify" function can be used to check whether a security strip has been sensitised or not. Place the book in the Model 955 as illustrated adjacent. Make sure that the light beam from the optical sensor is not interrupted. The lamp in the "verify" butto...

Troubleshooting 5 Troubleshooting Malfunction Possible causes Remedy The sensitising / desensitising pulse is not triggered. The optical sensor is dirty. Clean the optical sensor with suitable materials (e.g. cotton wool buds). The security marker is not activated / deactivated although the sensitis...

Technical Data 6 Technical Data Design: Table-top model Application: Sensitising and desensitising of 3M Security Strips Method of re/desensitizing: Electromagnetic pulse Sensitising and de-sensitising time: Less than 0.1 seconds Surrounding requirements: Recommended operating temperature 10 °C to 3...