3M 9237 62-9237-9930-8 - Manuals

General Information Thumb pressure on the feeder pushes the adhesive stick intothe heat block. The adhesive is melted by the heat block andpushed out through the tip. A fixed thermostat on the heatblock maintains heat block temperature. Start-Up and Operation WARNING: USE ONLY 3M™ SCOTCH-WELD™ HOT M...

Troubleshooting Problem Probable Cause Correction 1. Low or no No heat Check to see that 120 VAC service is on. Thermal fuse in the adhesive flow thermostat may have blown. Use Repair Kit #9262. Shutdown procedure was not observed Allow the applicator to heat up for at least 30 minutes. Plugged tip ...

Information générale Une pression du pouce sur le distributeur pousse le bâtond'adhésif dans le tampon isolant. L'adhésif fond avec letampon isolant et il est poussé dans l'embout. Un thermostatfixé sur le tampon isolant maintient la température du tamponisolant constante. Démarrage et fonctionnemen...