3M 9237 62-9237-9930-8 - Manual
3M 9237 62-9237-9930-8 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – ENGLISH
- Page 5 – Troubleshooting; Problem
- Page 6 – FRANÇAIS
- Page 8 – ESPAÑOL
3
Scotch-Weld
™
Hot Melt Applicator LT
Applicateur thermofusible 3M
™
Scotch-Weld
™
LT
Aplicador por fusión al calor de Scotch-Weld
™
LT de 3M
™
OWNER’S MANUAL
MANUEL DE L’UTILISATEUR
MANUAL DEL PROPIETARIO
For use with Low Melt Adhesives
Utilisez avec les adhésifs à faible point de fusion
Para uso con adhesivos de baja fusión
3
Sc
otc
h-W
eld
™
Ho
t M
elt
Ap
pli
cat
or L
T
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
General Information Thumb pressure on the feeder pushes the adhesive stick intothe heat block. The adhesive is melted by the heat block andpushed out through the tip. A fixed thermostat on the heatblock maintains heat block temperature. Start-Up and Operation WARNING: USE ONLY 3M™ SCOTCH-WELD™ HOT M...
Troubleshooting Problem Probable Cause Correction 1. Low or no No heat Check to see that 120 VAC service is on. Thermal fuse in the adhesive flow thermostat may have blown. Use Repair Kit #9262. Shutdown procedure was not observed Allow the applicator to heat up for at least 30 minutes. Plugged tip ...
Information générale Une pression du pouce sur le distributeur pousse le bâtond'adhésif dans le tampon isolant. L'adhésif fond avec letampon isolant et il est poussé dans l'embout. Un thermostatfixé sur le tampon isolant maintient la température du tamponisolant constante. Démarrage et fonctionnemen...
