3Com AP2750 - Manuals - manualsarea.com

Page 2 - Com AP2750 Managed Access Point Features

3Com AP2750 Managed Access Point Features Feature Description Power Port The access point can be powered either via Power Over Ethernet (PoE), or by an external power supply (not included) that is plugged into the Power Port. Serial Port The serial port is not supported. Ethernet Port The Ethernet p...

Page 3 - Mounting bracket (attached to the access point); Preparing for Installation

Observing Safety Precautions This equipment must be installed in compliance with local and national building codes, regulatory restrictions, and FCC rules. For the safety of people and equipment, only professional network personnel should install the access point. 1 Unpacking the Access Point Make s...

Page 4 - Each antenna requires the purchase of a separate antenna cable.

3 Attaching the Antennas Carefully unpack the standard detachable antennas. Screw the antennas on to the antenna connectors on the access point and hand-tighten them. After network startup, you may need to adjust the antennas to fine-tune coverage in your area. For best results, adjust the antennas ...

Page 5 - Mounting the Access Point; The access point can be mounted on the following types of surfaces:; Wall, Ceiling, or Electrical Box Mounting; To mount the access point to a wall, ceiling, or electrical box:; Remove the access point from the mounting bracket.

4 Mounting the Access Point The access point can be mounted on the following types of surfaces: • Wall, ceiling, or electrical box (NEMA enclosure) • Tabletop . Wall, Ceiling, or Electrical Box Mounting To mount the access point to a wall, ceiling, or electrical box: 1 Remove the access point from t...

Page 6 - Snap the access point onto the mounting bracket.; Installing the mounting bracket; Inserting the locking bar

The figures below show the mounting bracket being mounted to a wall, and then a cable being routed through the large opening on the back of the mounting bracket. 4 Connect the Ethernet cable (and power cable, if applicable) to the port(s) on the front of the access point. 5 Snap the access point ont...

Page 7 - Tabletop Mounting; Place the access point on the table.; Connecting the Access Point to a Switch; is clear of obstructions and provides good reception.

Tabletop Mounting To install the access point on a flat surface such as a table or desktop: 1 Remove the backing from the four rubber feet and attach them on the bottom of the mounting bracket that is attached to the access point. 2 Place the access point on the table. 3 Connect the Ethernet cable (...

Page 8 - Refer to the

Copyright © 2006 3Com Corporation. All rights reserved. 3Com and the 3Com logo are registered trademarks of 3Com Corporation. All other company and product names may be trademarks of the respective companies with which they are associated. Part Number 10015413 Rev. AA Published July 2006 6 Checking ...