3Com 3CR100AV97 - Manuals - manualsarea.com

Page 2 - Com Corporation; FCC Class A Statement; UNITED STATES

3Com Corporation 5400 Bayfront Plaza Santa Clara, California 95052-8145 Copyright © 2001 3Com Corporation. All rights reserved. No part of this documentation may be reproduced in any form or by anymeans or used to make any derivative work (such as translation, transformation, or adaptation) without ...

Page 3 - Introduction; Internet Service Provider

1 Congratulations on choosing the 3Com ® OfficeConnect ® Gateway, your ADSL (Asymmetric Digital Subscriber Line) broadbandaccess solution. This guide describes how to set up theOfficeConnect Gateway Data and Voice (3CR100AV97) base unit. The OfficeConnect Gateway allows one or more networkedcomputer...

Page 4 - Figure 1; Using Rubber Feet and Stacking Clip

Figure 1 2 Unpack the contents and ensure that it includes the followingitems: • AC/DC, 18 watt Power Adapter and Power Cord • LAN Cable, RJ-45 (CAT-5), Blue • ADSL Cable RJ-11/RJ-11, Black • One RJ-11, 7-ft telephone cable, Silver • Rubber feet (4) • Stacking clip PositioningtheGateway PackageConte...

Page 5 - LAN Connection; Note; : If you will be using

3 The ports and cables of the OfficeConnect Gateway products arecolor-coded to help you connect the cables properly. The following illustration shows the connector cabling: To connect the OfficeConnect Gateway’s cables: 1. Connect the DSL cable. Connect the DSL cable (black) to the ADSL wall jack an...

Page 6 - Checking for Dynamic or Static IP Addressing; Obtain an IP address automatically; Where To Go from here...

D H C P : ( D y n a m i c H o s tConfiguration Protocol) : Dynamic IP addressing is thetype of addressing schememost often used by InternetService Providers (ISPs), andis also the type that is preva-l e n t i n m a n y e x i s t i n gcorporate networks. The OfficeConnect Gateway,w h i c h c a n a c ...

Page 7 - admin; Unprotected User; Figure 4

5 Configurethe Gateway The following procedure describes how to initially configure theWide Area Network (WAN) interface settings for yourOfficeConnect Gateway or re-configure them after resetting theunit to its factory default settings. Using a web browser on your PC, launch the OfficeConnectGatewa...

Page 8 - Important; : Before you begin, ensure that you have obtained all; Figure 7

RFC1483DynamicConfiguration WANConfiguration RelatedDocuments The only information required for an RFC 1483 configuration in adynamic environment are the VPI/VCI numbers from your ISP.The DHCP Client over WAN setting is enabled, and unless instructed otherwise, the IP Routing Protocol should be set ...

Page 10 - Rebooting the OfficeConnect Gateway Data and Voice Base Unit:; Reset Button; Connecting an additional hub:; : If you previously used static addressing, use Chapter 2 of; Uplink port configuration; Figure 8

Rebooting the OfficeConnect Gateway Data and Voice Base Unit: To reboot an OfficeConnect Gateway Data and Voice unit that ispowered up, press and hold the Reset button for at least twoseconds. Reset Button The Reset button is located on the rear panel of the OfficeConnectGateway Data and Voice Base ...

Page 13 - Returning Products for Repair

Returning Products for Repair Before you send a product directly to 3Com for repair, you mustfirst obtain a Return Materials Authorization (RMA) number.Products sent to 3Com without RMA numbers will be returned tothe sender unopened, at the sender’s expense. To obtain an RMA number, please call the ...

Page 14 - Com Corporation Limited Warranty; Hardware

12 3Com Corporation Limited Warranty The duration of the warranty for the OfficeConnect Gateway is Lifetime. Hardware 3Com warrants the OfficeConnect Gateway to be free from defects in workmanship and materials,under normal use and service, for lifetime from the date of purchase from 3Com or its aut...