3Com 3C17715 - Manuals

3Com 3C17715 – Manual in PDF format online.

Manuals:

Manual 3Com 3C17715

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6

Summary

Page 2 - Handling the Module; Handle the Module only by its edges and front panel.; Installing the Module into a Switch; To install the Module:; Removing the Module from a Switch; To remove the Module:; Figure 2; NSTALLING

WARNING : Installation and removal of the Module must be carried out by qualified personnel only. Before installing the Module into a unit, you must first disconnect the unit from the mains power supply. For full safety instructions, refer to the user guide that accompanies the unit. AVERTISSEMENT :...

Page 3 - One standard XRN Interconnect Cable (3C17721); Figure 3; To interconnect two Switches:; LED Function Tables; Table 1; Table 2; When using the Interconnect Module, note the following:

Interconnecting Two Switches To interconnect two Switches, you will need the XRN Interconnect Module Kit (part number 3C17715). This kit contains: „ Two XRN Interconnect Modules (3C17716) „ One standard XRN Interconnect Cable (3C17721) You can interconnect two Switch units that are located in separa...

Page 4 - Online Technical Services; Check the 3Com knowledgebase at; Telephone Support; ROBLEM

. If you suspect a problem, carry out these steps before contacting your supplier: „ Check that the Interconnect Module is correctly installed in the Switch. When you insert the Module into the Switch, push the Module in until the Module’s back plate is in full contact with the Switch’s chassis. Sec...

3Com Manuals