3Com 10/100BASE-T - Manuals

Page 4 - ONTENTS

C ONTENTS 1 O VERVIEW Contacting 3Com................................................................................... 1-1Document Conventions .......................................................................... 1-2Product Description ............................................................

Page 5 - VERVIEW; This chapter provides an overview of:; Contacting 3Com

1 O VERVIEW This chapter provides an overview of: ■ Contacting 3Com ■ Document conventions ■ Product description ■ Product compatibility Contacting 3Com Call the appropriate toll free number listed below for technical support. For European countries that do not have a toll free number listed, call +...

Page 6 - These tables list conventions used throughout this guide.; commands

1-2 C HAPTER 1: O VERVIEW Refer to the Total Control Hub Documentation CD-ROM for more information regarding product warranty. For information about Customer Service, including support, training, contracts, and documentation, visit our website at http://totalservice.3com.com Document Conventions The...

Page 7 - Product Description; HiPer Access Router Card

Product Description 1-3 Product Description The PCI Dual 10/100Base-T Ethernet Network Interface Card (NIC) provides an Ethernet interface between a particular Network Application Card (NAC) in the 3Com Total Control chassis and your network. This NIC features two high speed Ethernet ports capable o...

Page 8 - NSTALLATION; Installation Tools; must

2 I NSTALLATION This chapter contains PCI Dual 10/100Base-T Ethernet Network Interface Card (NIC) installation information. Installation Tools To install this NIC in the Total Control chassis, you need a #2 Phillips and flat-head screwdriver. Installation Procedure To install this NIC: ESD: To reduc...

Page 11 - Insert the NIC between the slot’s upper and lower card guides.

2-4 C HAPTER 2: I NSTALLATION 4 Insert the NIC between the slot’s upper and lower card guides. 5 Slide the NIC into the chassis, until the front of the NIC is flush with the chassis.

Page 12 - Cover any unused chassis slots with safety panels.

Installation Procedure 2-5 6 Use a flat-head screwdriver to tighten the screws on the front panel. 7 Cover any unused chassis slots with safety panels. 8 Install the Network Application Card (NAC) corresponding to this NIC. Refer to the NAC’s Getting Started Guide for more information.

Page 13 - Physical Interfaces; Callout

3 N ETWORK I NTERFACE C ARD C ABLING This chapter provides information about the physical interfaces of thePCI Dual 10/100Base-T Ethernet Network Interface Card (NIC) and instructions for accessing the corresponding Network Application Card (NAC) through the user interface (UI). Physical Interfaces ...

Page 15 - LED

A T ROUBLE C LEARING AND T ECHNICAL S PECIFICATIONS Trouble Clearing This table describes Ethernet port LEDs and provides trouble clearing information. The Ethernet port must be configured properly in order to transmit and receive data. Refer to the NAC’s Product Reference guide for additional hardw...

Page 16 - FCC Part 15 Compliance Statement

A-2 A PPENDIX A: T ROUBLE C LEARING AND T ECHNICAL S PECIFICATIONS Technical Specifications Certification EMC Safety Regulatory Compliance Statements United States FCC Part 15 Compliance Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursua...

Page 17 - Interface; Electrical specification

Technical Specifications A-3 Interface Specifications RS-232 Port Ethernet 10Base-T/100 Base-TX Ports Electrical specification RS-232-C (EIA/TIA-232-E standard) Connector RJ-45, 8 position modular jack Configuration Data Terminal Equipment (DTE) Transmission method Unbalanced RS-232 Transmission rat...