3Com 09-0487-002 - Manuals

3Com 09-0487-002 – Manual in PDF format online.

Manuals:

Manual

Manual 3Com 09-0487-002

Summary

Page 2 - Corrections in the User Guide; Software-Related Corrections; The corrections below are software corrections:; Page 2-14: Check the Baud Rate Setting After; Enter the disconnect command.

2 LinkBuilder FDDI Workgroup Hub User Guide Release Note The system software has been preloaded into the hub management module flashmemory. Downloading the image to the FDDI Workgroup Hub disrupts thering. The download sequence isolates the hub from the ring during the power-on self-test (POST) and ...

Page 3 - Press the RESET button once, or enter the reset command.; Press the RESET button again.; Press Ctrl-P to enter Primitive console; The hub is now in the primitive console command mode.

3 LinkBuilder FDDI Workgroup Hub User Guide Release Note Removing modules from the hub with the power on will not damage thehardware. However, the software may not be able to distinguish betweenintentional removal and catastrophic failure of a media module. As a result,some errors will be entered in...

Page 4 - route dump and route add Commands; A metric of 0 indicates that the entry is a host.

4 LinkBuilder FDDI Workgroup Hub User Guide Release Note After flash memory has been verified, the status LED turns green when thesystem is fully initialized. Within a short time, the modem initialization stringAT&F is briefly displayed. When the AT&F display disappears, you can accessthe ma...