Boss Audio Systems FDR-1 - Manual

Page 3 - Main Features; Uses COSM technology to model the amp sound of a Fender; About the Fender

3 Main Features ● Uses COSM technology to model the amp sound of a Fender ® DELUXE REVERB ® . ● Makes it easy for you to enjoy that vintage Fender ® amp sound simply by connecting the FDR-1 to your usual guitar amp. ● Features reverb and vibrato effects like those on an actual DELUXE REVERB ® amp. *...

Page 4 - Panel Descriptions; * If the AC adaptor is connected while power is

4 Panel Descriptions fig.FDR-1_name1.eps 1. AC Adaptor Jack This jack accepts the connection of an AC adaptor (optionally available BOSS PSA-se-ries). By using an AC adaptor, you can play without being concerned about how much battery power you have left. * Use only the specified AC adaptor (PSA- se...

Page 7 - Connections

7 Connections * Inserting a connecting plug into the INPUT jack turns on the power to the unit. * Raise the amp volume only after turning on the power to all connected devices. * The use of an AC adaptor is recommended as the unit’s power consumption is relatively high. Should you prefer to use a ba...

Page 8 - Recommended Settings; required before the unit will operate normally.

8 Connections Recommended Settings fig.FDR-1-connenct-e.eps * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power-up is required before the unit will operate normally. AC AdaptorBOSS PSA-series(option) 9V DC/200 mA Guitar Amplifier (JC-120 etc.) Electric Gui...

Page 9 - Recommended Settings for a Fender

9 Connections Recommended Settings for a Roland JC-120 fig.FDR-1_JC-120.eps Recommended Settings for a Fender ® Combo Amp fig.FDR-1_TWINREVERB.eps Recommended Settings for a Stack Amp fig.FDR-1_JCM2000.eps We recommend using a clean setting (no dis-tortion) on the connected amp. Set to OFF BRIGHT TR...

Page 10 - Operating the Unit

10 Operating the Unit fig.FDR-1_operation1.eps 1. After you have made the necessary connections (p. 7, p. 8 ) , set the panel knobs as shown in the illustration. 2. Depress the pedal switch to turn the effect on. (The CHECK indicator lights when the effect is on.) fig.FDR-1_operation2.eps 3. Adjust ...

Page 12 - Setting the Vibrato Rate Using the Pedal Switch (RATE Setting Mode)

12 Operating the Unit Setting the Vibrato Rate Using the Pedal Switch (RATE Setting Mode) When Setting the Vibrato by Inputting the Tempo with the Effect On (CHECK indicator: Red) fig.FDR-1_vibrato1.eps * Vibrato rate for use with the tempo settings can be made in the range of 0.3–3.0 seconds.* If y...

Page 14 - Changing the Battery

14 Changing the Battery When the indicator goes dim or no longer lights while the effect is on, it means that the battery must be replaced. Replace the battery following the steps below. * The use of an AC adaptor is recommended as the unit’s power consumption is relatively high. Should you prefer t...

Page 15 - Troubleshooting; Is the LEVEL knob set too low?; Is the battery low or dead?

15 Troubleshooting The power won’t come on/the CHECK indicator doesn’t light ● Is the specified adaptor (PSA-series, sold separately) properly connected? Check the AC adaptor connection (p. 7, p. 8). * Never use any AC adapter other than one specified for use with the FDR-1. ● Is the battery low or ...

Page 16 - Setting Samples; Standard Crunch Sound

16 Setting Samples Standard Crunch Sound fig.FDR-1-sample1.eps Hard Overdrive Sound fig.FDR-1-sample1.eps Surf Rock Sound fig.FDR-1-sample1.eps Vibrato Sound fig.FDR-1-sample1.eps For details about the vibrato rate, please refer to p. 12, p. 13. FDR-1_e1.book 16 ページ２００７年１月５日　金曜日　午後６時７分

Page 17 - Setting Memo

17 Setting Memo fig.FDR-1-memo.eps fig.FDR-1-memo.eps fig.FDR-1-memo.eps fig.FDR-1-memo.eps FDR-1_e1.book 17 ページ２００７年１月５日　金曜日　午後６時７分

Page 19 - Specifications; or greater

19 Specifications FDR-1: Deluxe Reverb Nominal Input Level: ....................... -20 dBuInput Impedance:.............................. 1 M Ω Nominal Output Level:.................... -20 dBuOutput Impedance: .......................... 2.2 k Ω Recommended Load Impedance:... 10 k Ω or greater Contr...

Page 21 - MEMO

Page 23 - NOTICE; FEDERAL COMMUNICATIONS COMMISSION

This product complies with the requirements of European Directive 89/336/EEC. For EU Countries For Canada This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement...

Boss Audio Systems FDR-1 - Manual

Table of Contents:

Summary

Other Boss Audio Systems Models