BMW 3 1993- User Manual

BMW 3 1993

BMW 3 1993– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
Page: / 32

Table of Contents:

  • Page 14 – Digital Diesel Electronics Version 1; Transfer interrupted!
  • Page 15 – Digital Diesel Electronics Version 2; Supplemental Restraint System Codes; DISCONNECT THE BATTERY
  • Page 19 – SRS Control Unit Connector; models
  • Page 20 – ELECTRONIC TRANSMISSION CODES
Loading the manual

BMW

DIAGNOSTIC TROUBLE CODES

(DTC)

All 1989-94 BMW vehicles are equipped with a self diagnostic system for the detection of injection faults. When a fault
is detected by the system the Electronic Control Unit (ECU) records the code corresponding to the defect in the ECU's
memory until either:

MOTRONIC 'PEDAL' FAULT CODES (CARB)

MOTRONIC INTERNAL TROUBLE CODES

DME 1.1, 1.2, 1.3

DME 1.7, 1.7.1 & 3.1

DME1.7.2

DME 3.3

DME 3.3.1

DME MS40

DDE 1

DDE 2

SUPPLEMENTAL RESTRAINT SYSTEM (AIRBAG) CODES

SRS 1

SRS 2

SRS 3

SPECIAL NOTE ON E24 & E30 SRS SYSTEMS

ELECTRONIC TRANSMISSION CODES

EGS 1.XX

EGS 1.XX Late Model

EGS 2.28

EGS 4.XX

EGS 7.XX

EGS 9.XX

BMW MOTRONIC 'PEDAL' FAULT CODES

(Models 1989-94)

All 1989-94 BMW vehicles are equipped with a self diagnostic system for the detection of injection faults. When a fault
is detected by the system the Electronic Control Unit (ECU) records the code corresponding to the defect in the ECU's
memory until either:

1) The vehicle battery or the ECU is disconnected.

2) The engine is started 60 times with no recurrence of the fault.

3) The ECU memory is cleared using the Bosch KTS300, CARSOFT BMW software or the CS1000 BMW hand

scanner.

To review the FAULT CODES from the ECU memory use the following procedure:

1) Turn the ignition switch to the 'engine run' position.

2) Depress the gas pedal to the floor 5 times.


1 of 32

11/15/00 9:55 AM

bmwcodes

http://www.baumtools.com/bmwcodes.htm

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 14 - Digital Diesel Electronics Version 1; Transfer interrupted!

DDE 1 Digital Diesel Electronics Version 1 FAULT MALFUNCTION 1 RPM Transmitter 2 Temperature Sensor - Fuel 3 Temperature Sensor - Engine Coolant 4 Pedal Position Transmitter 5 Boost Pressure Sensor 6 Throttle Position Potentiometer 7 Boost Pressure Regulator 8 Air Mass Position 10 Speed Regulator 11...

Page 15 - Digital Diesel Electronics Version 2; Supplemental Restraint System Codes; DISCONNECT THE BATTERY

DDE 2 Digital Diesel Electronics Version 2 FAULT MALFUNCTION 0 Undefined Fault 1 Air Mass Positioner 3 Electronic Turn off Unit 5 Start of Injection Transmitter 6 Glow Period Regulator 10 Start of Injection Regulator 15 Voltage Supply DDE Control Unit 20 Speed Regulator 21 Throttle Position Potentio...

Page 19 - SRS Control Unit Connector; models

Diagnostic Tool PlugPin SRS Control Unit Connector E24 models Pin #14 Battery (+) Battery (+) Terminal Pin #15 (RxD) Pin #6 (WT/YL) Pin #19 Ground Good Vehicle Ground Pin #20 (TxD) Pin #2 (WT/VI) E30 Pin #14 Battery (+) Battery (+) Terminal Pin #15 (RxD) Pin #6 (WT/YL) Pin #19 Ground Good Vehicle Gr...

Other BMW Models

All BMW Other