BMW K25 R1200GS -- User Manual
BMW K25 R1200GS -– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Tightening torques
- Page 4 – headlights
- Page 6 – Technical data
- Page 11 – Precondition; motorcycle
- Page 12 – Disconnect; KOMET; from the motorcycle and screw the cap onto the; BMW Motorrad; battery charger from the motorcycle.; Finishing work
77 51 001 Installing LED auxiliary headlights
(14 FRUs)
+ 77 51 502
Equipment trim-level variant:
LED auxiliary headlights
Note
Not all the components contained in the installation kit are necessary for
installing the auxiliary headlights.
Note
Conversion/retrofit also work without registration with the
BMW Motorrad
diagnostic system. Registration is advisable, however, so that they will
subsequently be detected by the system whenever work is carried out with
the diagnostic unit.
Note
The LED auxiliary headlights have an overheat cutout. The headlights
automatically reduce their brightness if a certain temperature is reached;
under extreme circumstances the headlights can even switch themselves off.
The headlights return to full brightness once they have cooled down
sufficiently.
Preparatory work
Removing front and rear seats
Removing left side cover
Removing left side panel
Remove the right side cover
Removing right side panel
Removing trim panels of fuel tank
Removing intake air pipe
Removing fuel tank
Core activity
(-) Preassembling brackets for both sides
Seat nut
(1)
in bracket
(2)
.
Insert LED auxiliary headlight
(3)
into bracket
(2)
.
Tighten screws
(4)
just tight enough to hold the LED auxiliary headlight in
position, so that beam throw can subsequently be adjusted.
OA
BMW-Motorrad - 0450 - R 1200 GS, K25 31
1/12
122012
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
(-) Installing brackets with LED auxiliary headlights on both sides Remove screws (1) ; these screws are no longer needed as longer screws will be installed instead.Slip flat nuts (2) onto fairing bracket (3) (arrow) . Hold the bracket complete with LED auxiliary headlight (4) in position. Install s...
(-) Securing control unit Install control unit (2) . Lower cover (1) and engage the clips (arrows) . (-) Installing wiring-harness adapter kit for LED auxiliary headlights Measure the length of the LED wiring-harness adapter kit and cut off this length with the plug from the auxiliary-headlight cabl...
(-) Routing wiring harness Seat retainer (1) on cable duct (2) . Technical data Fuse for auxiliary headlight 7.5 A Route cable (3) forward along wiring harness (4) as far as the Y-branch and clip it into clip (5) . Continue routing cable (3) up along wiring harness (4) until it reaches the control-u...
