B&K ST260 - Manual - manualsarea.com

Page 3 - Table of contents

Page 1 Table of contents Safety Precautions Page 2 Purpose and function Page 3 Design and construction Page 3 Features Page 4 Rear panel view Page 4 Rear panel description Page 5 Control muting Page 5 - 6 Level controls Page 6 Inputs Page 7 Outputs Page 8 Internal Bus Page 9 Jumper description Page ...

Page 4 - SAFETY PRECAUTIONS; PLEASE READ BEFORE INSTALLING; Do not alter or remove them.

Page 2 SAFETY PRECAUTIONS PLEASE READ BEFORE INSTALLING WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNITTO RAIN OR MOISTURE. The lightning flash with arrowhead, within an equilateral triangle, is intended to alert theuser of the presence of uninsulated “dangerous voltage” within the...

Page 7 - DO NOT POWER MOTORS WITH THIS CIRCUIT.

Page 5 Rear panel description 1. AC fuse holder - Holds the AC Line fuse. This fuse is an 8 Amp / 250 VoltSlow Blow fuse. Replace with same type and value fuseonly. 2. AC Input receptacle - For attaching the supplied AC power cord to the amplifier. 3. Speaker outputs - For connecting the speakers to...

Page 8 - Level controls

Page 6 )LJXUH% If the control function is desired, each unit in the system must remain connected at alltimes and the control must be enabled. To enable the control function, the CTRLENABLE button must be out for each controllable amplifier in the system. For moreinformation on the amplifiers output ...

Page 9 - Inputs

Page 7 )LJXUH& )LJXUH' Example: When using 4 ohm and 8 ohm speakers together, the 4 ohm may soundlouder then 8 ohm at a given volume level. The level controls on the amplifier are usedto match the speakers volume level. Clockwise will increase the output. Counterclockwise will decrease the outpu...

Page 10 - Outputs

Page 8 )LJXUH( Outputs Five way binding posts are provided. One pair for each channel. They are designed toaccept a banana-type plug or spade lug connector (shown below) and are color codedfor easy identification. The red (+) post should always be connected to the speakers (+)jack. The black (-) pos...

Page 15 - not

Page 13 System installation There will most likely be a number of cables involved in the installation of your homeentertainment system. Pre-planning is essential in order to maximize system efficiency. We recommend the following as a means of helping you reach that goal: Make a diagram of your propo...

Page 17 - Troubleshooting; PROBLEM; DO NOT USE A HEAVIER; Care and cleaning

Page 15 Troubleshooting PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION No sound (‘on’ LED not illuminated) 1. Power cord not plugged in. 2. Power off at AC source. 3. AC power inlet fuse blownor faulty. 4. Control switch in the wrongposition. 1. Reconnect power cord. 2. Check AC switch or fuse. 3. Check f...

Page 19 - B&K Components Ltd. 2100 Old Union Road, Buffalo New York 14227

Page 17 Limited Warranty B&K Components Ltd., referred to herein as B&K, warrants your B&K equipment against all defects inmaterial and workmanship for a period of five years from the date of purchase. This warranty appliesonly to the original purchaser and only to equipment in normal re...

B&K ST260 - Manual

Table of Contents:

Summary

Other B&K Models