BISSELL 6860 EN- User Manual

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; To reduce

3 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and befo...

Page 5 - How To Use This Guide; Attach Handle To Vacuum; How To Put It Together; Attach Vacuum Hose and Tools

How To Use This Guide This User’s Guide has been designed to help you get the most satisfaction from your BISSELL Vacuum. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assembling ...

Page 6 - Attach Vacuum Hose and Tools Continued; Crevice Tool; Handle Positions; Brush; How To Use Your Vacuum; TurboBrush

Snap the Telescoping Extension Wand, Crevice Tool, and Combination Tool into storage clips as shown. On Board TurboBrush ® (Select Models Only) The TurboBrush Bracket slides onto the Hanger on the front of the Handle. Attach the Bracket by aligning the slots with the rectangular part on the Hanger a...

Page 7 - Power Height Adjustment

The Powerfoot on your vacuum can be adjusted to clean several floor surfaces. NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Place Handle in Upright Position. Turn Height Adjustment Knob to desi...

Page 8 - Select Models Only; Cleaning With The Detachable Canister

TurboBrush ® (Select Models) : Use rotating brush action for small areas such as stairs and upholstery. Note: Press gently when using TurboBrush to gain maximum cleaning. Too much pressure could cause the brush to stop rotating. Deluxe Bare Floor Tool (Select Models): Use for bare floors. Swivel hea...

Page 9 - Transporting Cleaner; Carrying Handle; Power Cord Storage; Buckle

9 Select Models Only The Shoulder Strap may be used while cleaning with the Detachable Canister. To attach the Shoulder Strap, wrap the Velcro ends attached to the bottom of the strap securely around the Canister handle as shown. To obtain maximum strength, overlap the loose ends completely and pres...

Page 10 - Full Line; Cleaning The Upper Tank & Filter; Screen; Empty Dirt Container; How to Maintain Your Vacuum

Upper Tank Knob To maintain maximum cleaning performance, the following maintenance steps must be performed: Empty the Dirt Container when the dirt reaches the “Full” line on the front. Check the Upper Tank and Pre-Motor Filters at least once a month and clean and replace as needed. Replace the HEPA...

Page 11 - Cleaning The Pre-Motor and Post-Motor Filters Maintenance; Rotating Brush and Drive Belt Maintenance

Unplug the cleaner from electrical outlet. The Pre-Motor Filter protects the motor from dirt particles. It is located in the slide out tray underneath the Dirt Container. If the filter becomes dirty, pull out the tray, lift out the filter and clean. This filter may be hand washed in cold water with ...

Page 12 - Replace Light Bulb; Belt Cover; Rotating Brush and Drive Belt Maintenance Continued

Place one end of the new Drive Belt over Motor Pulley and the other end over the Brush in the space between the bristles. Pull the Brush firmly to stretch the Drive Belt and place ends of Brush down into slots on sides as shown. Turn Brush several times by hand to center the Drive Belt. Reposition B...

Page 13 - If this; Clearing Clogs; Air Passageway

Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs. Unplug cleaner from electrical outlet. Empty Dirt Container. Check Upper Tank for build up or clogs. Remove the Upper Tank a...

Page 14 - Troubleshooting

Vacuum cleaner won’t run Possible Causes Remedies Power cord not plugged in Check electrical plug Blown fuse/tripped breaker Check/Replace fuse or reset breaker Thermal protector activated Allow cleaner to cool for 30 minutes, see pg. 13 No Power at Rotating Floor Brush Possible Causes Remedies Cani...

Page 15 - Saturday; Or visit our Website -; Item Part No. Part Name

15 Replacement Parts – BISSELL Lift-Off Revolution Series BISSELL Consumer Services 1 2 3 4 5 6 7 8 9 10 12 13 14 For information about repairs or replacement parts, or questions about your warranty, call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. —...

Page 16 - Warranty; Limited One Year Warranty; If your BISSELL product should require service:; *EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY

Warranty 16 This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, o...

BISSELL 6860 EN- User Manual

Table of Contents:

Summary

Other BISSELL Models