Page 2 - hanks for buying a BISSELL vacuum
2 T hanks for buying a BISSELL vacuum 2 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 We’re glad you purchased a BISSELL vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL vacuum is well made, and w...
Page 3 - MPORTANT SAFETY INSTRUCTIONS; REaD all InStRUctIonS; to reduce; SaVE thESE
3 I MPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: REaD all InStRUctIonS bEfoRE USInG yoUR UpRIGht VacUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and bef...
Page 4 - roduct view
4 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 Handle TurboBrush ® Power Switch Clean Filter Indicator (Select Models Only) Easy Empty ™ Dirt Container Headlight Height Adjustment Knob Foot Window Washable Pre-Motor Filter Scuff Resistant Bumper Carrying Handle Lock ‘n Seal ® Lever HEPA Med...
Page 5 - Attach handle to vacuum; ssembly
5 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 the only tool you’ll need to assemble your vacuum cleaner is a phillips screwdriver. Attach handle to vacuum 1 . Locate the handle and cord wrap. Remove the screw packet taped to the handle. 2. Stand the vacuum upright and from the rear of the ...
Page 6 - Attach vacuum hose and tools; left; Power switch; the power switch is located just below the
Attach vacuum hose and tools 1. Line up the tabs on the base of the Twist ‘n Snap hose with the corresponding notches on the hose collar as shown. 2. Turn the Twist ‘n Snap hose to the left to lock the hose into place. 3. Connect the curved hose wand to the hose. Grasping the curved hose wand, slide...
Page 7 - Transporting cleaner; peration; Before cleaning under low furniture, check
3. Handle positions press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions. 1. Upright – For storage and above floor cleaning with tools. 2. normal cleaning – Press handle release pedal once. Position use...
Page 8 - Clean filter indicator; right; Special on-board tools; your vacuum is not only a powerful carpet and
Clean filter indicator Select Models OnlyThe clean filter indicator tells you when the air flow in your vacuum is reduced due to dirty filters or a clog in the hose. The clean filter indicator will remain green while the unit is running until the airflow is reduced by a clog or dirty filter. At that...
Page 9 - turbobrush; Power cord usage; Hair, string and small objects can block
crevice tool: Use in tight narrow spaces. Extension Wand: Use with desired attachment for a longer reach. curved hose Wand: Use with desired attachment for a longer reach or for cleaning hard to reach places. turbobrush ® : Use rotating brush action for small areas such as stairs and upholstery. not...
Page 10 - Empty dirt container; aintenance and care; To maximize cleaning performance, check
to maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters frequently. perform the following maintenance steps: 1. Empty the dirt container when the dirt reaches the “Full” line on the container, ...
Page 11 - Do not operate cleaner
1. Unplug the vacuum from electrical outlet. 2. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. If the filter becomes dirty, pull out the tray, lift out the foam filter pad and clean it. notE: the pre-motor filter may be...
Page 12 - to reduce the risk of injury
check rotating floor brush and drive beltyou should check your vacuum cleaner’s rotating floor brush and drive belt regularly for wear or damage. you should also clean the brush and brush ends of strings, hair and carpet fibers. this type of debris can wrap around the brush and hamper its ability to...
Page 14 - Maintaining TurboBrush; the turbobrush should be checked regularly for
14 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Maintaining TurboBrush the turbobrush should be checked regularly for clogs or debris wrapping around the brush.1. Unplug the vacuum from electrical outlet. 2. If a clog is present or debris is visible, unscrew the two sc...
Page 15 - Clearing clogs; low suction or poor pickup may be due to a clog
15 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Clearing clogs low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs. 1. Unplug the vacuum from electrical outlet. 2. Empty dirt container...
Page 17 - roubleshooting; Vacuum cleaner won’t turn on; to reduce the risk of electric shock,
17 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 T roubleshooting Vacuum cleaner won’t turn on possible causes Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker. Vacuum cleaner and tools won’t pick up d...
Page 18 - bISSEll consumer Services; Saturday; Or visit the BISSELL website -; ISSELL Consumer Services; authorized service representative.; thank you for selecting a bISSEll product.; please do not return this product to the store.; for any questions or concerns, bISSEll is happy to be of service.
18 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 For information about repairs or replacement parts, or questions about your warranty, call: bISSEll consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare, Inc.PO Box 3606Gra...
Page 19 - eplacement parts - BISSELL Vacuum; please note, all attachments may not store on board your vacuum.; Item
16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 19 R eplacement parts - BISSELL Vacuum you may purchase parts from your retailer, by calling bISSEll consumer Services or by visiting our website. below is a list of common replacement parts. While not all of these parts may have come with you...
Page 20 - limited one year Warranty; If your bISSEll product should require service:
16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 20 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 W arranty - BISSELL PowerTrak ® Cyclonic and Momentum ® Vacuums This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If y...