BISSELL 6750 - User Manual

5 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 The only tool you’ll need to assemble your vacuum cleaner is a Phillips screwdriver. Attach handle to vacuum 1 . Locate the handle and cord wrap. Remove the screw packet taped to the handle. 2. Stand the vacuum upright and from the rear of the ...

Attach vacuum hose and tools 1. Line up the tabs on the base of the Twist ‘n Snap hose with the corresponding notches on the hose collar as shown. 2. Turn the Twist ‘n Snap hose to the left to lock the hose into place. 3. Connect the curved hose wand to the hose. Grasping the curved hose wand, slide...

Handle positions Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions. 1. Upright – For storage and above floor cleaning with tools. 2. Normal Cleaning – Press handle release pedal once. Position used f...

Transporting cleaner 1. To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward. 2. The cleaner can also be moved by using the carry handle. Clean filter indicator The clean filter Indicator tells you when the air flow...

Special on-board tools Your vacuum is not only a powerful carpet and rug cleaner, it’s also a versatile above floor vacuum cleaner when you select one of the special tools. 1. Raise the handle to the upright position. 2. Grasp the curved hose wand handle to sepa-rate from hose wand base. 3. Attach t...

Power cord usage 1. To use your vacuum, remove the cord and plug it into an electrical outlet. For your convenience, there are two quick release cord wraps for easy cord removal. There is also a cord clip that is part of the upper cord wrap where you can attach the cord when vacuuming. 2. When you a...

Empty dirt container The dirt container needs to be emptied when the dirt reaches the “Full” line on the container. 1. Unplug the vacuum from electrical outlet 2. Slide the Lock ‘n Seal Lever to the “Unlock” position. 3. Grasp handle and pull the dirt container straight out to remove from the vacuum...

Check rotating floor brush and drive belt You should check your vacuum cleaner’s rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair and carpet fibers. This type of debris can wrap around the brush and hamper its ability t...

13 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Replace drive belt 1. Unplug the vacuum from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (Steps 1-4 of check rotating floor brush and drive belt), grasp old drive belt and remove from motor...

14 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Replace lightbulb 1. Unplug the vacuum from electrical outlet. 2. Using a flat bladed screwdriver, pry the tab on the left and right side out and pull out to remove the lens. 3. Remove the bulb from the socket by grasping...

15 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Clearing clogs Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs. 1. Unplug the vacuum from electrical outlet. 2. Empty dirt container...

16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Cleaning the upper tank 1. Grasp the inner cyclone and twist to the left or to the unlocked marking, until the locking tabs stop the rotation. Pull down from the upper tank to remove it. 2. Wipe out the inside of the uppe...

17 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 T roubleshooting Vacuum cleaner won’t run Possible causes Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker 3. Damaged power cord 3. Unplug, check for da...

16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 18 For information about repairs or replacement parts, or questions about your warranty, call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare, Inc.PO Box 3606...

16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 19 R eplacement parts - BISSELL vacuum You may purchase parts from your retailer, by calling BISSELL Consumer Services or by visiting our website. Below is a list of common replacement parts. While not all of these parts may have come with you...

16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 20 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 W arranty - BISSELL Pet Hair Eraser ™ Vacuum This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional ...