BISSELL 6595 - User Manual - manualsarea.com

Page 2 - Thanks For Buying A BISSELL Lift-Off®

2 Thanks For Buying A BISSELL Lift-Off® We’re glad you purchased a BISSELL Lift-Off Vacuum. Everything we know about floor care went into the design and construction of this powerful, high-tech home vacuuming system. Your BISSELL Lift-Off is well made, and we back it with a limited comprehensive one...

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; To reduce

3 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and befo...

Page 5 - How To Use This Guide; Standard Models; Twist ‘n SnapTM Hose Models -; Attach Handle To Vacuum; How To Put It Together; Attach Vacuum Hose and Tools; Twist ‘n Snap Hose Models

How To Use This Guide This User’s Guide has been designed to help you get the most satisfaction from your BISSELL Lift-Off. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assemblin...

Page 6 - Attach Vacuum Hose and Tools Continued; Crevice Tool; Handle Positions; Brush; How To Use Your BISSELL Lift-Off; TurboBrush

Slide the end of the Hose Grip onto the Hose Grip Base. Place the Hose into the Hose Clip. NOTE: The Powerfoot will not operate effectively unless the Hose is firmly attached to the base. Snap the Telescoping Extension Wand, Crevice Tool, and Combination Tool into storage clips as shown. On Board Tu...

Page 7 - Power Height Adjustment

The Powerfoot on your BISSELL Lift-Off can be adjusted to clean several floor surfaces. NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Place Handle in Upright Position. Turn Height Adjustment Kn...

Page 8 - Cleaning With The Detachable Canister

Telescoping Extension Wand: Use with desired attachment for a longer reach. To extend the Wand, twist the collar to “Unlock” position and push away from you. Twist the collar to the “Lock” position to lock into place. To retract, twist to unlock, pull toward you and twist to relock. TurboBrush® (Sel...

Page 9 - Select Models Only; Transporting Cleaner; Carrying Handle; Shoulder Strap

9 Select Models Only The Shoulder Strap may be used while cleaning with the Detachable Canister. To attach the Shoulder Strap, wrap the Velcro ends attached to the bottom of the strap securely around the Canister handle as shown. The length of the strap may be adjusted as required for comfort Select...

Page 10 - How to Maintain Your BISSELL Lift-Off; Full Line; Empty Dirt Container; Cleaning The Upper Tank & Filter

Upper Tank Knob How to Maintain Your BISSELL Lift-Off To maintain maximum cleaning performance, the following maintenance steps must be performed: Empty the Dirt Container when the dirt reaches the “Full” line on the side. Check the Upper Tank and Pre-Motor Filters at least once a month and clean an...

Page 11 - Cleaning The Pre-Motor and Post-Motor Filters Maintenance; Rotating Brush and Drive Belt Maintenance

Use only BISSELL Style 8 Replacement Filters in your BISSELL Lift-Off ® . Unplug the cleaner from electrical outlet. The Pre-Motor Filter protects the motor from dirt particles. It is located in the slide out tray underneath the Dirt Container. If the filter becomes dirty, pull out the tray, lift ou...

Page 12 - Replace Light Bulb; Belt Cover; Rotating Brush and Drive Belt Maintenance Continued

Place one end of the new Drive Belt over Motor Pulley and the other end over the Brush in the space between the bristles. Pull the Brush firmly to stretch the Drive Belt and place ends of Brush down into slots on sides as shown. Turn Brush several times by hand to center the Drive Belt. Reposition B...

Page 13 - For Models with the Twist 'n Snap Hose; If this; cools for approximately 30; Clearing Clogs; Air Passageway

Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs. Unplug cleaner from electrical outlet. Empty Dirt Container. Check Upper Tank for build up or clogs. Remove the Upper Tank a...

Page 14 - Troubleshooting

Vacuum cleaner won’t run Possible Causes Remedies Power cord not plugged in Check electrical plug Blown fuse/tripped breaker Check/Replace fuse or reset breaker Thermal protector activated Allow cleaner to cool for 30 minutes, see pg. 13 No Power at Rotating Floor Brush Possible Causes Remedies Cani...

Page 15 - Saturday; Item Part No. Part Name; Replacement Parts – BISSELL Lift-Off Series; BISSELL Consumer Services; Saturday

You may purchase replacement parts from your retailer, by calling BISSELL Consumer Services or by visiting our website. To locate a retailer near you, or to place an order using Visa, MasterCard, Discover or American Express, call BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 ...

Page 16 - Warranty; Limited One Year Warranty; If your BISSELL product should require service:; *EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY

Warranty 16 This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, o...

BISSELL 6595 - User Manual

Table of Contents:

Other Manuals for BISSELL 6595

Summary

Other BISSELL Models