BISSELL 48K2 - Manual

5 w w w . b i s s e l l . c o m A ssembling your vacuum 1 . Connect swivel hose by squeezing both locking buttons and inserting it into the suction opening on the canister. Once the swivel hose is inserted in the suction opening, release the locking buttons. 2 . Plug the cord from the hose into the ...

O perations 6 w w w . b i s s e l l . c o m Special tools Your BISSELL CleanAlong is not only a powerful carpet and rug vacuum cleaner, it’s also a versatile bare floor vacuum cleaner and above floor vacuum cleaner when you select one of the special tools. Powerhead: The CleanAlong comes with the po...

O perations 7 w w w . b i s s e l l . c o m Power cord The power cord is located at the rear of the vacuum. Gently pull out the power cord, watching for the yellow line. Stop pulling the power cord once the yellow line is visible. There is also a red line, which indicates the end of the usable cord....

8 w w w . b i s s e l l . c o m O perations Variable height adjustments Step on the brush height adjuster located on the right side of the motorized powerhead to adjust for flooring type (lowest setting (1)for non-carpet, indoor areas, highest setting (6) for plush pile carpet). Handle position Pres...

9 w w w . b i s s e l l . c o m O perations Bag change indicator The bag change indicator is located between the power button and the automatic cord rewind button. If the bag change indicator turns orange while you are vacuuming, the dust bag needs to be replaced. The dust bag may appear to be full ...

10 w w w . b i s s e l l . c o m Cleaning the pre-motor filter The pre-motor filter protects the motor from dirt and dust particles. 1. Unplug the vacuum from electrical outlet. 2. Disconnect hose 3. Open the dust bag compartment by lifting up on the latch on the door at the front of the vacuum. Lif...

11 w w w . b i s s e l l . c o m M aintenance and care The post-motor HEPA media filter assists in the filtration process to return clean air to the room. 1. Unplug the vacuum from electrical outlet. 2. Remove the filter door (located on the rear of the vacuum) by pulling up on the filter door latch...

12 w w w . b i s s e l l . c o m M aintenance and care Cleaning the motorized powerhead The brush can usually be cleaned without removal from the vacuum. If there is an excessive amount of hair and debris, however, it is best to remove the brush. 1. Unplug the vacuum. 2. Lay the motorized powerhead ...

13 w w w . b i s s e l l . c o m T roubleshooting Vacuum cleaner won’t run Possible causes Remedies 1. Vacuum cleaner is not plugged in 1. Check electrical plug 2. Power button is not pressed down 2. Press power button down Vacuum cleaner won’t pick up or low suction Possible causes Remedies 1. Tool...

14 w w w . b i s s e l l . c o m B ISSELL Consumer Services For information about repairs or replacement parts, or questions about your warranty, call or write: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET BISSELL Homecare, Inc. Saturday 9 a.m. — 8 p.m. ET PO Box 3606...

R eplacement parts - BISSELL CleanAlong Item Part No. Part Name 1 203-7270 Dust Bag (3pk) 2 203-7268 Pre-Motor Filter 3 203-7269 Post-Motor HEPA Media Filter 4 203-7309 Barefloor Tool 5 203-7310 Floor Brush 6 203-7315 Hose Grip with Powercord 7 203-7314 Extension Wand with Power Cord 8 203-7273 Upho...

16 w w w . b i s s e l l . c o m W arranty - BISSELL CleanAlong Canister Vacuum ©2008 BISSELL Homecare, IncGrand Rapids, MichiganAll rights reserved. Printed in ChinaPart Number 110-4075Rev 12/08Visit our website at:www.bissell.com This warranty gives you specific legal rights, and you may also have...