Bertazzoni PROF30FDEXV - User Manual

6 / Before installation • This appliance shall only be installed by anauthorized professional. If the installation requires alterations to the dome-stic electrical system, call a quali fi ed electrician. The electrician should also check that the socket cable section is suitable for the electricity ...

7 INSTALLING THE OVEN IN A CABINET Ensure that the oven is fully present and undamaged after removing all loose parts from their inner and outer packaging. In the event of any uncertainty, do not use the appliance and contact technical support.Check that the kitchen unit is suitable for installation...

8 / Before installation INSTALLING THE OVEN IN A TALL APPLIANCE HOUSING The oven can be installed in a standard or fl ush application. Finish the edges of the opening because they may be visible when the door is open.The clearance between the oven and the kitchen units must be enough to ensure su ffi ...

9 / Before installation Flush installation Flush installation with reduced clearance Ensure there is an opening in the top or bottom of the cabinet as shown in the fi gure. BEFORE INSTALLATION 53" 1346 25" 635 (1) (1) Spacers - Parts of standard equipment (1) CUT OUT FORPOWER CORD (4" x ...

10 / Installation requirements / Electrical connection ELECTRICAL A properly-grounded horizontally- mounted electri-cal receptacle should be installed no higher than 3” (7.6 cm) above the fl oor, no less than 2” (5 cm) and no more than 8” (20,3 cm) from the left side (facing product). Check all loca...

11 / Installation requirements / Electrical connection FOUR-WIRE CONN.RECEPTACLE NEMA 14-50R Check your local code for which of the options be-low should be used in grounding the receptacle power supply connections. FOUR Wires connection: -Connect the L1 receptacle terminal to the inco-ming BLACK el...

12 / Wiring diagram WIRING DIAGRAM The electric wiring diagrams and schematics are attached behind the range, and should not be removed except by a service technician, then replaced after service. 30” XT $ / 1 / *5281' % &1 &1 &1 % % % % & &1 &9 7 - / 7 - / 0 %3'; 3& %36;...

14 / Installation APPLIANCE INSTALLATIONUnpacking the oven To avoid risk of severe personal injury and da-mage to the unit and fl ooring; this appliance requires two or more personnel while handling and moving. Possible use of appliance dollies moving devices is recommended • Remove all packing mate...

15 REMOVING THE OVEN DOOR Prepare the door for removal. Flip up the locking clamps on each door hinge. Slowly shut the door until the protruding clamps stop the movement. Pull oven door upwards and remove. Do not lift or carry the oven door by its handle! This may damage the hinges. The oven door is...

16 INSTALLATION CHECKLIST FINAL PREPARATION A quali fi ed installer should carry out the following checks: Make sure the clearance to cabinet surfaces cur-responds to manufacturers guidelines. Make sure the oven is level and securely fi tted to the cabinet. Check that lower trim is undamaged. Open t...

17 BERTAZZONI SERVICE Bertazzoni is committed to providing the best cu-stomer and product service. We have a dedicated team of trained professionals to answer your ne-eds.If you own a Bertazzoni appliance and need ser-vice in the US or Canada please use the following contact information: e-mail: [em...