Page 2 - TABLE OF CONTENTS
2 / Table of contents TABLE OF CONTENTS WARNINGS ___________________________________________________________________ DATA RATING LABEL ___________________________________________________________ BEFORE INSTALLATION ________________________________________________________ VENTILATION PREPARATION ____...
Page 4 - WARNINGS; Leave these instructions with the; DO NOT install this range outdoors.; To avoid risk of property damage, personal; •If you cannot reach your gas suppliers, call; Warning - tipping hazard
4 / Warnings WARNINGS To ensure proper and safe operation, the applian-ce must be properly installed and grounded by a qualifi ed technician. DO NOT attempt to adjust, repair, service, or replace any part of your ap-pliance unless it is specifi cally recommended in this manual. All other servicing sho...
Page 5 - WARNING
5 / Warnings Engage the range to the anti-tip device by anti-tip brackets or anti-tip chain (see installing the an-ti-tip device chapter). Ensure the anti-tip device is re-engaged when the range is moved. Re-engage the anti-tip device if the range is mo-ved. Do not operate the range without te anti-...
Page 6 - / Data rating label / Before installation; Type of gas; DATA RATING LABEL
6 / Data rating label / Before installation The data rating label shows the model and serial number of the range. It is located under the con-trol panel and in the last page of this manual. • This appliance shall only be installed by an au-thorized professional. • This appliance shall be installed i...
Page 7 - Select Hood and Blower Models:; / Ventilation preparation / Specifi cations; VENTILATION PREPARATION
7 This range will best perform when installed with Bertazzoni exhaust hoods. These hoods have been designed to work in conjunction with the Bertazzoni range and have the same fi nish for a perfect look. Before installation of the exhaust hood, consult lo-cal or regional building and installation code...
Page 9 - / Clearence dimensions; CLEARENCES DIMENSIONS; Installation adjacent to kitchen cabinets
9 / Clearence dimensions CLEARENCES DIMENSIONS Installation adjacent to kitchen cabinets This range may be installed directly adjacent to existing countertop high cabinets (36” or 91.5 cm from the fl oor). For the best look, the worktop should be level with the cabinet countertop. This can be accompl...
Page 10 - / Installation requirements / Electrical connection; ELECTRICAL; INSTALLATION REQUIREMENTS; installation area for the connection
10 / Installation requirements / Electrical connection ELECTRICAL A properly-grounded horizontally- mounted electri-cal receptacle should be installed no higher than 3” (7.6 cm) above the fl oor, no less than 2” (5 cm) and no more than 8” (20,3 cm) from the left side (facing product). Check all local...
Page 11 - WIRING DIAGRAM; GE
11 / Wiring diagram WIRING DIAGRAM The electric wiring diagrams and schematics are attached behind the range, and should not be removed except by a service technician, then replaced after service. MV 1234 P 2 P 1 P 3 P 4 COM Comm.2+0 G L N GV M Simb. Description r Red gr Green (earth) v Violet a Ora...
Page 12 - MANUAL SHUT-OFF VALVE; A ‘T’ handle type manual; FLEXIBLE CONNECTIONS; The unit must be installed; PRESSURE TEST-POINT STOPPER; GAS CONNECTION; GAS PIPE
12 / Gas connection Warning! DO NOT USE AN OPEN FLAME WHEN CHECKING FOR LEAKS! Leak testing of the appliance shall be conducted according to the manufacturer’s instructions. Be-fore placing the oven into operation, always check for leaks with soapy water solution or other accep-table method. Check f...
Page 14 - REMOVING THE OVEN DOOR; Pull oven door upwards and remove.; Do not lift or carry the oven door by its handle!; This may damage the hinges.; INSTALLATION
14 / Installation APPLIANCE INSTALLATIONUnpacking the range • Remove all packing materials from the ship-ping pallet but leave the adhesive-backed foam layer over brushed-metal surfaces to protect it from scratches until the range is installed in its fi nalposition. Only the fi lm on the side panels s...
Page 15 - Fix the front guard with it’s two screws
15 / Installation INSTALLING THE LEGS Bertazzoni ranges must be used only with the legs properly installed.Four height-adjustable legs are supplied with the range in the polysterene container situated over the appliance.Before installing the legs, position the appliance near its fi nal location as th...
Page 16 - INSTALLING THE ISLAND TRIM
16 INSTALLING THE ISLAND TRIM The island trim must be installed prior to operation of the appliance for appropriate ventilation of the oven compartment.The island trim is only placed on the cooktop, re-move all tape and packaging before installing it. INSTALLING BACKGUARD (OPTIONAL) The backguard mu...
Page 17 - INSTALLING THE ANTI/TIP DEVICES; CLOSED RING
17 ANTI-TIP BRACKETS The anti-tip bracket shipped with the range must be properly secured to the rear wall as shown in the picture below. The height of the bracket from the fl oor must be determined after the range legs have been adju-sted to the desired height and after the range has been levelled. ...
Page 18 - GAS CONVERSION; Step 1: pressure regulator; LP
18 GAS CONVERSION Warning! Before carrying out this operation, disconnect the appliance from gas and electricity.Gas conversion shall be conducted by a fac-tory-trained professional.Call the customer service hotline to identify a fac-tory-trained professional near your home. The gas conversion proce...
Page 19 - DISEGNI; To replace the nozzles of the main oven bur-
19 DISEGNI Step 3: oven burner (main or auxiliary) To replace the nozzles of the main oven bur- ner, start by removing the door and the bot- tom panel of the oven. Remove the screw located on the right side of the burner and pull out the burner from its support. ATTENTION: pay extra attention to avo...
Page 20 - Oven; Step 6: minimum fl ame adjustment
20 Step 4: broiler burner Remove the screw and pull out the burner from its support. ATTENTION: pay extra attention to avoid damage to the igniter and thermocouple. Unscrew the nozzle located inside the gas fi tting using a 7 mm [socket wrench]. Replace the nozzle as table number 1. Step 5: visual ch...
Page 22 - / Installation checklist / fi nal preparation
22 INSTALLATION CHECKLIST FINAL PREPARATION A qualifi ed installer should carry out the following checks: Range mounted on its legsIsland trim or Backguard attached accor-ding to instructionAnti-tip device properly installedClearance to cabinet surfaces as manu-facturer’s guidelineProper ground conne...
Page 23 - BERTAZZONI SERVICE
23 BERTAZZONI SERVICE Bertazzoni is committed to providing the best cu-stomer and product service. We have a dedicated team of trained professionals to answer your ne-eds.If you own a Bertazzoni appliance and need ser-vice in the US or Canada please use the following contact information: e-mail: [em...