B&B Electronics 232SS21600 - Manual

Table of Contents:

• Page 3 – Table of Contents; TABLE OF CONTENTS
• Page 4 – Chapter 1: INTRODUCTION; The master port can be configured as a DTE or DCE port by an; NOTE: The data format and rates mentioned are used to switch; There are four LED's on the 232SS2 to indicate which port is
• Page 5 – Checklist; Examine the shipping carton and contents for physical damage.
• Page 6 – Setting
• Page 7 – Port Configuration; In order to determine the proper port configuration of the
• Page 8 – Serial Data Configuration
• Page 9 – Smart Switch Operation; NOTE: There is no delay through the Smart Switch and the
• Page 10 – Programming the Second Character; The second character comes programmed as the ASCII STX; Binary File Transfer; A simple method of using the Smart Switch to transfer binary; Programmable Character Setting; WEIGHT
• Page 11 – Smart Switch/Port Combiner Mode; This mode allow Ports A-D to select the master port using a
• Page 13 – Table 3 - Timer Values; The Set Timer Mode command requires the third byte to be an
• Page 14 – Specifications
• Page 15 – Installation
• Page 16 – DOS SSTSR
• Page 17 – Type GO and press the ENTER key.; Once the GO.BAT file is created, every time you wish to begin; Command
• Page 18 – Parameters; Port
• Page 19 – The Hot Key is a sequence of three keys that must be pressed; Default Values; If you type SSTSR on the command line with no parameters, or; Help Screen; If you are installing the SSTSR using the SSTSR.COM method,; The SSTSR may be un-installed easily by typing SSTSR - and; Selecting Ports; There are two different ways in which a Smart Switch port is
• Page 21 – Appendix A; APPENDIX A: ASCII Character Codes
• Page 22 – Appendix C; APPENDIX B: Cable Charts; All charts will indicate if the Master Port of the 232SS2 should be; Straight Through Connection; GROUND
• Page 23 – Null Modem Connection
• Page 26 – FCC Class A Equipment Statement; Class A Equipment; This equipment has been tested and found to comply with the