Avanti BCA4561B-2 - Manual
Avanti BCA4561B-2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Affixing the Metal bracket to the refrigerator; Illustration # 2
- Page 3 – Illustration # 4
- Page 4 – Side view of completed installation.; Illustration # 5
1
Installation & Assembly
Microwave Oven Bracket Installation Instruction
For use with the following Avanti models:
Microwaves – MO7082MB, MO7191TW, MO7192TB, MO7103SST& MO8003BT
Refrigerators – Can be used with all Compact, Midsize & Counterhigh models except the
RM4550W-2, RM4551B-2, RM4589SS-2 and BCA4561B-2
Parts List &
Hardware
Before you start this installation make sure you have all the parts listed below.
Read entire installation sheet before you start assembly of this item.
Part Number
Qty
Description
A
MOM9705
1
Mounting Bracket
B
9705-001
1
Allen Wrench
C
9705-002
4
No. 8 x 1” Phillips Pan Head
Sheet Metal Screw
D
9705-003
4
Plastic Anchor (¼” x 1”)
E
9705-004
4
No. 8 x 5/8 Phillips Hex Head
Self Tapping Screw & Washer
Installation Procedures:
1)
Bracket Configuration:
Holes (A) and (B) are the existing holes in the upper part of the Metal bracket to be attached to the
microwave oven. Holes (C), (D), (E) and (F) are also existing holes in the lower part of the Metal bracket to
be installed on to the refrigerator. See illustration #1.
Illustration #1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Instructions below are for refrigerators with a solid top. If installing on refrigerator with a decorative (plastic) top skip to Step #4 2) Installation of the lower side of the Metal bracket to the Refrigerator: Lay and center the Metal bracket on top of the refrigerator as close to the back as p...
3 5) Inserting the Plastic Anchors to the Refrigerator: Insert the four (4) Plastic Anchors provided into the four (4) holes (step 3) in the rear portion of the top of the refrigerator. See illustration # 2 6) Affixing the Metal bracket to the refrigerator Align the four (4) holes of the lower part ...
4 7) Side view of completed installation. Once you have completed all 6 of the above steps the completed Metal bracket will appear as shown in illustration # 5. Illustration # 5
