Audiovox PRO 9644aUGH - Manual
Audiovox PRO 9644aUGH – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – PROTECTION WHILE THE SYSTEM IS ARMED
- Page 6 – MANUALLY OVERRIDING YOUR SYSTEM:
- Page 8 – Enter the vehicle and turn the ignition switch to the on position.
- Page 10 – SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS; UltraGuard Security Systems 15600 Roscoe Blvd., Van Nuys, CA 91406
128-6885
1 of 10
Model PRO 9644aUGH
Owner’s Manual
3 Button Remote Security System with Starter Disable
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situa-
tions. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected.
Valet
Switch manual override is pre-selected from the factory, however, the system can be
configured for "Custom Code" operation. Confirm the override mode selected on the last page
of this manual and familiarize yourself with the section on it's operation.
FEATURES :
w
2 Three Button Programmable RF Transmitters (capable of accepting 4 transmitters)
w
Separate Lock/Unlock Transmitter Buttons
w
Five Channel Receiver
w
Code Hopping Technology
w
Selectable Manual Override Mode
w
Remote Panic in all modes (Improved)
w
Protected Valet
w
User Programmable Manual Override Code
w
Intrusion Alert with Memory
w
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w
Instant Siren Activation
w
Starter Disable
w
True Last Door Arming ( hardwire only )
w
Defective Zone By-Pass
w
Hardwire or Voltage Sense Selectable
w
Active or Passive Arming Selectable
w
Smart Disarming
w
Programmable Auto Lock On / Off
w
Programmable Auto Unlock On / Off
w
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w
Programmable Active or Passive Door Locks
w
User Programmable Permanent Chirp Delete
w
On Command RF Chirp Delete from Transmitter Or Selectable Through Software
w
6 Tone Multi-Tone Siren, (And Or),
w
Car Horn Activation for additional alarm response
w
Additional Negative Trigger Input
w
RF Inhibit with ignition on
w
Parking Light Flasher
OPTIONS :
w
7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w
Remote Trunk Release ( must have electronic trunk release )
w
Remote Keyless Entry ( must have power door locks )
w
Illuminated Entry
w
Multiple Vehicle Capable
w
Headlight Illumination during Arming and or Disarming
w
Remote Starter
w
Remote Power Window Roll Up
w
Remote Garage Door Interface
w
Plug In Electronic Shock Sensor
w
Interior Illumination Upon Disarm
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-6885 3 of 10 If the siren "chirped" three times, sometime after arming, the exclusive delayeddome light learn circuit has been programmed and the system detected a openentry point after the learned delay expired. Closing the hood, trunk, or doors willcorrect the problem and you do not ne...
128-6885 6 of 10 If the LED is flashing one time...pause...one time...pause...etc., then an intrusion attempt was made to the OPTIONAL shock sensor, or an accessory triggeringdevice that may have been added to the system. If the LED is flashing two times...pause...two times...pause...etc., then ...
128-6885 8 of 10 Page 8 NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5 seconds during any of the above steps, the unit will revert back to the lastsuccessfully stored code. MANUALLY OVERRIDING YOUR SYSTEM: USING THE CUSTOM CODE OVERRIDEAssuming the ...
