AT&T UPAM-K - Manual
AT&T UPAM-K – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – To Order Copies of This Manual:; Your AT&T Information Systems Sales Representative; Your Business Sales and Service Center; or; AT&T Customer Information Center; For Technical Assistance Call :
- Page 6 – TelephoneAccess; UPAM; Components; -conductor modular connector cord
- Page 7 – Preannounce and Confirmation Tones
- Page 8 – Important Power Supply Note
- Page 10 – Connect “Tip” of trunk port to T terminal on UPAM.; Trunk Port Connections — Loop Start
- Page 11 – Mount and ground the UPAM as described in General Instructions.; Set mode switch S3 to ON position and S4 to OFF position (see Note 1).
- Page 12 – Installation Manual; Trunk Port Connections – Ground Start
- Page 13 – Disconnect methods; in the ON position and proceed as follows:; Rotate VOX DELAY control approximately 1/2 way.
- Page 14 – Inhibit default timer; available when the default timer is inhibited):; Changing default time; Important Centrex Modification; UPAM disconnects from the line immediately after answering.
- Page 15 – Replace cover in reverse order of Step 1.; Station Port/Centrex Connections
- Page 17 – -Conductor Modular Plug (shown with locking tab facing back)
- Page 18 – * Refer to the illustration on the previous page; Page Port Connections
- Page 19 – Make sure that the amplifier is turned off.; Connect one side of the amplifier input to the UPAM PT terminal.; Turn amplifier volume control to minimum.
- Page 20 – Typical Connection to a Lo-Z/600 ohm input
- Page 21 – Connecting the UPAM to an amplifier’s Hi-Z AUX input; Typical Connection to a Hi-Z input
- Page 22 – Connecting the UPAM to an amplifier’s MIC input; Make sure the amplifier is turned off.; Typical connection to a MIC input
- Page 23 – Connecting the UPAM to a self-amplified paging system; Typical connection to a self-amplified paging system
- Page 25 – Take test set off hook.; Procedure B; Place the test set in the monitor position.; Troubleshooting Notes; Latching relays
AT&T
UPAM-K
Universal Paging Access Module Kit
Installation Manual
Document No. 518-600-031
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
To Order Copies of This Manual: Your AT&T Information Systems Sales Representative or Call: Your Business Sales and Service Center or The AT&T Customer Information Center, 1-800-432-6600 AT&T Customer Information Center Write: P.O. Box 19901Indianapolis, IN 46219 Order: Document Number 5...
1 1. Product Identification Installation Manual UPAM-K Universal Paging Access Module Kit The UPAM-K Universal Paging Adaptor Module Kit designed to provide telephone access to most commonly available paging systems. It works with loop- and ground-start trunk ports, station ports orpaging ports, and...
Installation Manual 2 Features ● ● ● ● ● ● ● ● Acts as point of demarcationActs as a point of demarcation between telephone system and customer paging equipment. 24V or 48V operation (trunk port operation)Mode switches let you select 24-volt or 48-volt operation. A 48-volt power supply is included t...
