AT&T ID-282H - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS

1 EN Table of Contents .............................................................................. 1 Getting started .................................................................................. 2 Handset registration ....................................................................... 3 ...

Page 3 - GETTING STARTED; ID-282H Package Contents; One Handset

EN 2 GETTING STARTED The AT&T ID-282H Accessory Handset is for use with the AT&T ID-2820Digital Cordless Telephone with Touch Sensitive Keypad. You must havethe AT&T ID-2820 Digital Cordless Telephone with Touch Sensitive Keypadin order to use the AT&T ID-282H Accessory Handset. This...

Page 4 - Setup of the ID-282H Accessory Handset; Plug the AC Adapter cord into the base unit and then into a wall; at least 15 hours; before registering the handset.; To register a new handset :; HANDSET REGISTRATION

3 EN Setup of the ID-282H Accessory Handset 1. Plug the AC Adapter cord into the base unit and then into a wall outlet. 2. Pull the battery contact tab out slowly and remove as shown.3. Place the handset in the charging cradle. The battery icon on the display will flash and the base indicator light ...

Page 5 - PAGE; key to activate the keypad; TOUCH PHONE USE AND HANDLING

EN 4 3. Touch to confirm. 4. You will see the message: ‘ REGISTERING... ’ . Press and hold the PAGE key on the cradle of the base unit. 5. ‘ REGISTRATION ACCEPTED ’ indicates that handset is registered. ‘ RETRY? ’ indicates that registration has failed. Touch to retry or to quit. NOTE : The base uni...

Page 6 - BASIC OPERATION

5 EN To adjust receiver / speakerphone volume: • Touch or during a call to raise or lower the volume. To make a call: 1. Touch and wait for a dial tone. 2. Enter destination phone number using numbers 0 - 9 . If you make an error, touch to cancel. To answer a call: • Remove the handset from the base...

Page 9 - To transfer a call between handsets:

EN 8 To page from base to handset(s): 1. Press PAGE on the base unit . 2. All of the handsets registered to the base will beep and the display will show PAGING. 3. Once the handset is located, press to discontinue paging. Intercom call: 1. Touch . 2. Use and to select ‘ INTERCOM CALL ’ from the menu...

Page 10 - Intercom Call

9 EN Headset installation • The ID-282H may be used with any industry standard two-band 2.5mmheadset, which must be purchased separately. Connect the headsetto the jack located on the side of the handset. Your phone is now readyfor headset use. You can purchase a suitable headset from AT&T orfro...

Page 11 - TROUBLESHOOTING; DO NOT

EN 10 PROBLEM Unable to makea call -OUT OF RANGEappears on thehandset Unable to make a call -NOT REGISTEREDappears on thehandset Unable to enter thesubmenus Caller ID is notdisplayed POSSIBLE CAUSES / REMEDIES • The handset is out of range of baseunit - move closer to the base • Interference due to ...

Page 13 - SAFETY INFORMATION; Never

EN 12 SAFETY INFORMATION Warning! AT&T DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOTexpose this unit to rain or moisture. Observe the following safetyprecautions and warnings when setting up and using this product. 1. R...

Page 14 - CAUTION; Battery Safety Precautions:

13 EN 11. Unplug this product from the wall jack and refer servicing to qualified service personnel under the following conditions: a) If liquid has been spilled onto the product. b) If the product does not operate normally by following the operating instructions. Adjust only those controls that are...

Page 15 - CARE AND MAINTENANCE

EN 14 2. Do not dispose of the battery pack in a fire; the cells may explode. Do not expose battery pack to water. Dispose of old, defective batterypacks in an environmentally - friendly manner in accordance with therelevant legislation. 3. Do not open or mutilate the battery pack. Released electrol...

Page 16 - Keep your phone away from hot, humid conditions or strong sunlight.; CARING FOR YOUR PRODUCT

15 EN • Handle the handset gently and carefully. Dropping it can damagecircuit boards and cases and can cause it to malfunction. • Keep the handset away from excessive dust and dirt. Which can causepremature part wear. • Occasionally wipe the handset with a damp cloth to keep it lookingnew. Do not u...

Page 17 - SPECIFICATIONS; DECLARATION OF CONFORMITY

EN 16 TYPE DESCRIPTION Handset L x W x H 5.55 x 1.73 x 0.94 in Handset weight 4.41oz (with battery) Base L x W x H 3.68 x 3.13 x 1.50 in Base Weight 2.6 oz Standard Worldwide Digital Cordless Telecommunication(WDCT) Frequency range 2.4GHz ISM Channel bandwidth 1.729MHz Modulation GFSK Communication ...

Page 20 - LIMITED WARRANTY

19 EN questions about what will disable alarm equipment, consult AT&TCustomer Service or a qualified alarm company. k. Privacy of communications may not be ensured when using the phone. NOTICE: According to telephone company reports, AC electrical surges, typically resulting from lightning strik...

Page 22 - WHAT DOES OUR WARRANTY COVER?; Any defect in material or workmanship.; FOR HOW LONG AFTER THE ORIGINAL PURCHASE?; AT&T Customer Service for Return Authorization; WHAT DOES OUR WARRANTY NOT COVER?; PROCEDURE FOR WARRANTY REPAIR

21 EN Q&A WHAT DOES OUR WARRANTY COVER? • Any defect in material or workmanship. FOR HOW LONG AFTER THE ORIGINAL PURCHASE? • To the original purchaser only - ONE YEAR. WHAT WILL AT&T DO? • At our option, repair or replace your unit. HOW DO I SEND MY UNIT, IN OR OUT OF WARRANTY? • In the U.S....

Page 23 - SAVE THESE INSTRUCTIONS; AT&T Customer Service Center at

EN 22 • Products serviced by the owner or a service facility not expresslyauthorized by AT&T Communications. • Products purchased more than 12 months from current date. • Units purchased in “ AS IS ” condition, or units purchased as “ Distressed Merchandise ” . HOW DOES STATE LAW OR PROVINCIAL L...

AT&T ID-282H - Manual

Table of Contents:

Summary

Other AT&T Models