AT&T BCM50 - Manual

Table of Contents:

• Page 2 – TABLE OF CONTENTS
• Page 3 – TABLE OF FIGURES
• Page 4 – Introduction; for advanced functionality. For more information and procedures,; Pre-IP PBX Configuration Activity; Company name
• Page 5 – Trouble Reporting
• Page 6 – Further explanation for software release in 4.1 and VoIP
• Page 7 – Special; Calling Number Restricted / Private not supported; restricted. This function is not supported.; BCM Soft Phones not currently supported
• Page 8 – Overview; Nortel IP 200x, 11xx, 12xx phones* – These phones use the Nortel
• Page 10 – PSTN
• Page 11 – Configuration; Nortel BCM50 Version and Feature Requirements; screen under; Administration; Figure 2: BCM50 Software Version Number
• Page 12 – Figure 3: BCM50 Lists of Applied Patches
• Page 13 – IP Trunks; signaling with AT&T IP Flexible Reach service.
• Page 14 – Figure 4: Available VoIP Trunks; can be done by going to; Figure 5: Application Resource availability of SIP (or IP) Trunks
• Page 15 – Under; Configuration; for an example configuration.; Figure 6: Assigning Line Pool to IP Trunks
• Page 17 – Figure 8: Configuring General DN Length
• Page 18 – define the Private Received number length to “4” digits.; Figure 10: Configuring Private Received Number Length
• Page 19 – “Routes” tab and ensure there is an entry for “BlocA.” In this case “001” is; Figure 11: Assigning a Route for IP Trunks
• Page 20 – Appendix ‘A’: Configuring Destination Code with Wildcard; Figure 12: Assign Code to Access IP Trunk Routes
• Page 21 – SIP Proxy Parameters; Select module; type “IP Trunks” and click on the “Sip Proxy” tab (see figures below).; Figure 13: Selecting IP Trunk Module
• Page 22 – using the SIP “OPTIONS” keep-alive approach. The BCM50 will send SIP
• Page 23 – Media Parameters; Voice Activity Detection:; Figure 16: SIP Media Parameters
• Page 24 – Figure 17: Configuring analog DNs for fax
• Page 25 – Port Ranges; analog phones. The media gateway port ranges are configurable.; Figure 18: Media Gateway Port Ranges
• Page 26 – Configuring Outgoing Calls from BCM50 to AT&T IP Flex Reach; Figure 19: Configuring DID for Outgoing Calls
• Page 27 – Configuring Incoming Calls from AT&T IP Flex Reach to BCM50; Figure 20: Configuring DID for Incoming Calls
• Page 28 – Figure 21: Display DID on IP Set LCD
• Page 29 – Figure 22: Assign Line Pool to IP Sets
• Page 30 – Troubleshooting; This section provides some tips about troubleshooting problems; System Monitoring with BCM Monitor; Overall system status; Figure 23: System Monitoring Example
• Page 31 – Figure 24: IP Device Listing
• Page 32 – Figure 25: RTP Session Information
• Page 33 – Figure 27: System Resources
• Page 34 – Real-time display of BCM50 Alarms; Figure 28: BCM50 Alarms Page
• Page 35 – Log Management; Figure 29: Log Management; captured if it does end up being required.
• Page 36 – APPENDIX A: Configuring Destination Code with; configure destination code with wildcard.; tab, add the destination code “9A” to use Normal Route; Figure 30: Configuring Destination Code with Wildcard
• Page 37 – its suppliers have been advised of the possibility of such damage.