AT&T 915 - Manual

5. Check for dial tone. Lift the handset and listen for a dial tone. If you cannot hear a dial tone, slide the VOLUME switch to the right. If you still do not hear a dial tone, see the In case of difficulty section beginning on page 15 of this user’s manual. 4 Installation Installation

Wall installation 1. Install batteries to provide power for the lighted dial pad. Press the battery cover tab and remove the cover. Install four new alkaline AA batteries (not included). Be sure to follow the polarity guide in the battery compartment. Replace the cover. 5 Installation Installation N...

Make a call Lift the handset. When you hear a dial tone, dial using the dial pad or memory buttons. Answer a call When you hear the phone ring and the ringing indicator turns on, you have an incoming call. Lift the handset to answerthe call. Ringing indicator The ringing indicator is lit when you ha...

Redial The last number dialed at this phone is stored in redial memory. To dial that number, lift the handset and listen for the dial tone, then press REDIAL/PAUSE . The number is dialed automatically. NOTE: Redial memory can store up to 32 digits. If the last number dialed was longer than 32 digits...

This telephone can store 13 telephone numbers, each up to 16 digits long. You can dial numbers stored in memory by pressing one or two buttons. Directory card Lift the plastic cover off the directory card to write the numbers (or names) stored in telephone memory on the card. Then replace the cover....

12 Store a pause in a memory number Press and release REDIAL/PAUSE once to store a three to four second pause in the dialing sequence. Each additional press will add another three to four second pause. NOTE: Each three to four second pause counts as one digit when storing numbers in telephone memory...

To keep your phone working and looking good, follow these guidelines: • Avoid putting it near heating appliances and devices that generate electrical noise (for example, motors or fluorescent lamps). • DO NOT expose it to direct sunlight or moisture. • Avoid dropping the phone and/or other rough tre...

REN 1.3B Power Four AA batteries are required for backlighting. Phone must also be connected to telephone line for all features to work. Line feed voltage 48V +⁄- 2V Line loop current 18mA to 100mA Ringer levels Off = 0dB HI = 85dB Compliance FCC and UL approved Memory One-touch memory: 3 Memory loc...

15 In case of difficulty In case of di ff iculty In case of di ff iculty If you have difficulty operating this phone, try the suggestions below. For Customer Service, visit our website at www.telephones.att.com or call 1 (800) 222–3111. In Canada, please call 1 (866) 288-4268 . Please retain your re...

Telephone operation Problem Solution Problem Solution Problem Solution Lighted dial pad is dim or does not work • Make sure you have installed four fully charged AA batteries (not included) following the polarity guide in the battery compartment. (See Installation beginning on page 2 of this user’s ...

AAUDIO ASSIST™ 10BBatteries 2, 5, 16D Lighted dial pad 2, 5Lighted dial pad is dim or do not work 16 Difficulty storing numbers in memory 16 Directory card 11FFlash 9HHandset tab 6 Handset volume 4, 7, 10 LLine cord 1, 3, 6, 15–16 MMemory 11–12, 16Memory button 8, 12Memory location 11–12Memory numbe...