AT&T 8102 - Manual - manualsarea.com

Page 2 - DEFINITY, Dimension and Merlin are registered trademarks of AT&T.

NOTICE While reasonable efforts were made to ensure that the information in thisdocument was complete and accurate at the time of printing. AT&T canassume no responsibility for any errors. Changes or corrections to theinformation contained in this document may be incorporated into futureissues. ...

Page 3 - Use

Contents Important Safety Instructions 1 Your 8102 and 8110 Telephones 5 Installing Your Telephone 12 Using the Features 21 Appendix A 31 Appendix B 33 Appendix C 35 Appendix D 36 FCC Registration and Repair Information 37 Interference Information 38 AT&T Warranty Information 39 Quick Reference ...

Page 5 - Service; to qualified service personnel when these conditions exist:; SAVE THESE INSTRUCTIONS; CONSIGNES DE SECURITE; Emploi; Lisez les instructions et soyez sûrs de les avoir comprises.

Service 1 Before cleaning, unplug the telephone from the modular wall jack.Do not use liquid cleaners or aerosol cleaners. Use a damp clothfor cleaning. 2 Unplug the telephone from the modular wall jack and refer servicing to qualified service personnel when these conditions exist: ● ● ● ● ● If liqu...

Page 7 - Entretien; CONSERVEZ CES INSTRUCTIONS

● Afin de réduire le risque de choc électrique, ne démontez pas letéléphone. Aucun composant réparable ou remplaçable parl'utilisateur n'est présent à l'intérieur du téléphone. Si vous ôtez lecouvercle du téléphone, vous risquez d'être exposés à des tensionsdangereuses. Si vous remontez le téléphone...

Page 11 - For placing and receiving calls.; For putting a call on hold.

Starting with the handset on the TOP VIEW and continuing clockwise: Data jack Auxiliarypower jack Handset Handset Program button Flash button Speaker button Handset jack Pause button Programmable Dialing buttons Hold button Hold light Redial button Auto Answer button Mute button Message light Redial...

Page 15 - Installing Your Telephone; Note: Although the drawings in this section show an 8110 telephone,; Table/Desk Installation; Feed the line cord through the line cord routing channel.; Turn the telephone right-side up and place it on your desk or table.; Plug the free end of the line cord into a modular jack.

Installing Your Telephone Note: Although the drawings in this section show an 8110 telephone, the following installation procedures are applicable for both the 8102 andthe 8110 telephones. Table/Desk Installation Use the 7-foot straight line cord that came with your telephone toconnect the telephone...

Page 17 - Wall Installation; You must reverse the handset tab (which holds the handset when; Turn the base so the larger end is down.

Wall Installation Use the following directions to mount the telephone on a standardwallphone jack with mounting studs. 1 You must reverse the handset tab (which holds the handset when 2 3 you hang up). See Figure 5. ● Hold down the switchhook and slide the tab up and out of its slot. ● Turn the tab ...

Page 19 - Plug the free end of the coiled handset cord into the handset and

8 9 10 Mountingstuds Base BaseLocking Tab FIGURE 7 Placing the Telephone on the Wall Jack Mounting Studs 6 7 Plug one end of the line cord into the line jack on the bottom of thetelephone. See Figure 8 for the location of the line jack. Voice Terminal Wall Note: You may prefer to use an 8" line ...

Page 21 - Labeling the Programmable Dialing Button Designation Card; dialing buttons designation card on your telephone.; Removing and Covering the Auto Answer Button; Lift the button from its slot on the face of the telephone. (You will

Labeling the Programmable Dialing Button Designation Card Use the following directions for labeling and inserting the programmable dialing buttons designation card on your telephone. Note: For directions on storing numbers on the programmable dialingbuttons, refer to "Programmable Dialing Button...

Page 23 - Using the Features; Note: At the end of this booklet is a one-page Quick Reference Guide; Using the Handset and Speakerphone; Note: The 8102 telephone has an Adjunct jack on the rear of the; Answering and Placing a Call; To answer a call; To place a call

FIGURE 11 Removing the Auto Answer button; Inseting the Button Slot Cover Using the Features The procedures which follow give short, step-by-step instructions forusing each feature. For your convenience, features are listed alphabetically. Note: At the end of this booklet is a one-page Quick Referen...

Page 25 - To place a call using the speakerphone (for 8110 users); Dial desired number; To end a call; Speak to caller; To turn off the Auto Answer feature

Answering and Placing a Call (cont.) To place a call using the speakerphone (for 8110 users) 1 While on-hook, press [ Spkr ] [dial tone] ● Red light next to [ Spkr ] goes on 2 Dial desired number To end a call 1 Hang up handseto rif you are using the speakerphone, press [ Spkr ] ● Red light next to ...

Page 27 - To put a call on hold; o r; Message; To prevent the other party from hearing you (To mute microphone)

Flash If your telephone is connected to a business communications system,you can use [ Flash ] instead of pressing the switchhook for such features as Conference or Call Waiting. Check with your System Administrator tosee which features you can use. If you are using your telephone at home and you su...

Page 29 - To program any of the 12 programmable dialing buttons; Note: Several depressions of the PAUSE buttons will produce a

Personalized Ring The 2 tone controls on the side of the telephone allow you to chooseyour own personalized ring pattern. Use to help distinguish yourincoming calls from those of other nearby telephones. The tone selector labeled HI--LO will help you select one of 2 tone ringerfrequencies. Slide the...

Page 31 - To automatically redial the last number dialed from the dial pad; or; To erase ALL stored access codes

To program an automatic pause for redialed numbers To dial a number with a programmable dialing button 1 Pick up handset o rif you are using an 8110 telephone, you can press [ Spkr ] 2 When you hear dial tone, press appropriate programmable dialingbutton ● Number programmed on the button is automati...

Page 33 - Appendix A

Speakerphone (for 8110 Users) Allows you to place and answer calls without lifting the handset. Useany time you prefer hands-free communication, both speaking andlistening, or for group conference situations. To place/answer a call without lifting the handset 1 Press [ Spkr ] ● Red light goes on nex...

Page 35 - Appendix B; Answering Calls; To end a call, press the Off button on the headset adapter.; Originating Calls; ] works the same with a headset adapter as it would; Putting Calls on Hold

Powersupply Adjunctcord Adjunctpower cord Adjunct(equipment)jack S201A Speakerphone (Top view) Line jack Adjunctpower jack 8102 Voice Terminal (Bottom view) FIGURE 12 Connecting Adjunct Equipment and an Adjunct Power Supply to an 8102 Telephone 32 Appendix B Operation of the 500A Headset Adapter(wit...

Page 37 - Switching from the Headset to the Handset; Appendix C; Auxiliary Power for the 8110 Telephone

Switching from the Headset to the Handset If you are on a call on the headset and want to switch to the handset,you can do so by lifting the handset. The call is now on the handset.Press the Off button on the headset adapter in order to turn off the lightnext to the On/Quiet button. To switch from t...

Page 39 - If Your Telephone Does Not Respond; Pick up the handset; INFORMATION FOR THE TELEPHONE COMPANY; bottom of your telephone equipment.; REPAIR INSTRUCTIONS

Appendix D FCC Registration and Repair Information If Your Telephone Does Not Respond If your 8102 or 8110 telephone does not respond to any button pressesor if it sounds as if it is dead, try the following procedure before seekingrepair assistance. 1 2 3 Pick up the handset Press the PROGRAM button...

Page 41 - RIGHT OF THE TELEPHONE COMPANY; Your telephone company may make changes in its facilities,; Interference Information; All terms and conditions specified in your; WHAT WE ASK YOU TO DO:; To get warranty service for your; FOR OPTIMAL PERFORMANCE:; The telephone automatic disconnect

● RIGHT OF THE TELEPHONE COMPANY If telephone equipment is causing harm to the telephone network, thetelephone company may temporality discontinue your telephoneservice. If possible, they’ll notify you before they interrupt service. Ifadvance notice isn’t practical, you’ll be notified as soon as pos...

Page 43 - Quick Reference Guide

Quick Reference Guide Storing Numbers in Memory 1 While the telephone is on-hook, press the PROGRAM button 2 Press programmable dialing button 3 Dial telephone number 4 Press the PROGRAM button Dialing Numbers in Memory 1 Pick up handset OR Press [ S p k r ] 2 Press programmable dialing button Erasi...

Page 44 - Using the Auto Answer Feature (For 8110 Users Only); When call comes in, speakerphone is activated

Using the Built-in Speakerphone (For 8110 Users Only) 1 2 3 4 5 To place or answer a call, press [ Spkr ]To mute the speakerphone microphone, press [ Mute ]To change from speakerphone to handset, pick up handset whileon speakerphoneTo change from handset to speakerphone, press [ Spkr ] and hang up h...

Page 45 - Telephones; User’s Manual