AT&T 1725 - Manual - manualsarea.com

Page 2 - I N S T A L L A T I O N

I N S T A L L A T I O N 1 Connect the line cord. Plug one end of the telephone linecord into the jack labeled TEL LINE on the back of the system. Plug theother end into a phone wall jack. 2 Connect the telephone. NOTE: If you do not want to connect a telephone, skip to Step 3. Plug the line cord fro...

Page 3 - O P E R A T I O N

O P E R A T I O N Record memo or phone conversation Set and hear time/day Access mailboxes Microphone Stop message playback Adjust listening volumeduring message playback Turn Audible Message Alert on or off Preview first five seconds of each message Delete all or selected messages Turn system on or...

Page 4 - Setting the Clock; About Mailboxes

O P E R A T I O N Setting the Clock You’ll need to set the clock so it can recordthe day and time each message is received. 1 Press and release g . The Message Window displays CH . 2 Press and release C . The current day setting is announced. 3 To change the day setting, hold down / or ? until the c...

Page 6 - Saving Messages; Deleting Messages

Listening to Your Messages As the system plays back messages in amailbox, the Message Window displays thenumber of the message playing. Beforeplaying each message, the systemannounces the day and time the messagewas received. After playing the lastmessage, the system announces “End ofmessages.” Play...

Page 7 - Priority Call Signal; Changing the Priority Calling Code; When Memory is Full

Recording a Memo You can record a memo to be stored as anincoming message. The memo can be upto three minutes long, and will be playedback with other messages. 1 Press and release W . All four mailbox lights blink rapidly. TheMessage Window should display 1– . If it displays 2– , press W again. 2 Pr...

Page 8 - Changing the Remote Access Code

O P E R A T I O N Changing the Remote Access Code The Remote Access Code is preset to 500.You can change the Remote Access Codeto any three-digit number from 500–999. DO NOT pick the same number as that assigned to the Priority Calling Code. 1 Press g . The Message Window displays CH . 2 Hold down c...

Page 9 - R E M O T E O P E R A T I O N

R E M O T E O P E R A T I O N Deleting Messages 1 Connect with the answeringsystem. 2 To delete selected message — Press and release 3 while the message is playing. To delete all messages in amailbox — After you have listened to all messages and heard the two beeps,press 3 , and then the mailbox num...

Page 10 - Ending Remote Access Call; Voice Help Menu

R E M O T E O P E R A T I O N Ending Remote Access Call Press * , 9 . The system announces “The machine will now hang up,” anddisconnects from the line. Changing YourRemote Access Code 1 Connect with the answeringsystem. 2 Press and release 9 , 9 . The system beeps once. 3 Enter your new Remote Acce...

Page 11 - I N C A S E O F D I F F I C U L T Y; Message Window Is Blank; Messages Are Incomplete; Power Failure Recovery

I N C A S E O F D I F F I C U L T Y If this answering system does not workproperly, try the following suggestions.If you’re still having difficulty, call1 800 222-3111. Message Window Is Blank • Make sure the power cord is securelyconnected to both the answeringsystem and an electrical outlet notcon...

AT&T 1725 - Manual

Table of Contents:

Summary

Other AT&T Models