Page 5 - Table of Contents; CHAPTER 1; CHAPTER 2; CHAPTER 3
i Table of Contents CHAPTER 1 ........................................................................................................................... 1 1.1 A N O VERVIEW OF ADSL M ODEM /R OUTER ................................................................................................. 1 1....
Page 6 - CHAPTER 4; APPENDIX
I-Fly Wireless Router ADSL ii 3.5.19 Admin Privilege – Miscellaneous Configuration .............................................................................. 50 3.5.20 Admin Privilege – Reset to Factory Default.........................................................................................
Page 7 - Chapter 1; Introduction; An Overview of I-Fly Wireless Router ADSL
1 Chapter 1 Introduction 1.1 An Overview of I-Fly Wireless Router ADSL ADSL Modem/Router provides a high-speed Ethernet port and an USB (Universal Serial Bus) port for high-speed Internet browsing. It can support downstream transmission rates of up to 8Mbps and upstream transmission rates of up to 1...
Page 8 - Package Contents
I-Fly Wireless Router ADSL 2 1.2 Package Contents 1. I-Fly Wireless Router ADSL 2. One CD-ROM containing the driver and online manual 3. One Quick Start Guide 4. One RJ-11 ADSL/telephone cable 5. One CAT-5 LAN cable 6. One USB cable 7. One power adapter 1.3 ADSL Modem/Router Features ADSL Modem/Rout...
Page 9 - Hardware Indicators; Front Panel; Port
Chapter 1 Introduction 3 can allocate multiple clients IP addresses and distribute them including IP address, subnet mask as well as DNS IP address to local computers. It provides an easy way to manage the local IP network. Web based GUI: Supports user-friendly web based GUI for configuration and ma...
Page 10 - Rear Panel
I-Fly Wireless Router ADSL 4 5 RxD The RXD Indicator light green when data traffic is receiving from the WAN port, the LED will rapidly flash green during data transfer 6 10/100 The 10/100 Indicator lights green when data traffic is data transfer.[On =100Mbps,Off =10Mbps] 7 Link/Act The LAN LINK Ind...
Page 12 - Hardware Installation
I-Fly Wireless Router ADSL 6 1.5 Hardware Installation Power on Connect the Adapter to power inlet and turn the power switch on, this product will enter a self-test phase. When it is in the self-test phase, the indicators READY LED will be lighted ON for about 8 seconds, and the READY LED will be fl...
Page 13 - Chapter 2; Using ADSL Modem/Router; Cautions for Using ADSL Modem/Router; Through USB Port; Through Ethernet Port
7 Chapter 2 Using ADSL Modem/Router 2.1 Cautions for Using ADSL Modem/Router Do not place the router under high humidity and high temperature. Do not use the same power source for the device with other equipment. Do not open or repair the case yourself. If the device is too hot, turn off the power i...
Page 15 - Chapter 3; Installation and Configuration; Installing the USB Driver
9 Chapter 3 Installation and Configuration 3.1 Installing the USB Driver If you connect the ADSL Modem/Router through USB port, for the first time the USB cable is connected to the PC, Windows will automatically detect the device. Follow the steps to install the USB driver. 3.1.1 For Windows XP 1. W...
Page 25 - Configuring the Network Properties
Chapter 3 Installation and Configuration 19 6. You will see the following screen prompting for the path of the Windows source files. Please specify a location. Click “ OK ”. 3.2 Configuring the Network Properties This section describes the configuration required by LAN-attached PCs that communicate ...
Page 33 - Factory Default Settings; admin; epicrouter; user; password
Chapter 3 Installation and Configuration 27 3.3 Factory Default Settings Before you configure this device, you need to know the following default settings. 1. Web Configurator Password: There are two levels of password protection, Administrator Level and User Level . User Name Password Administrator...
Page 34 - Information from ISP
I-Fly Wireless Router ADSL 28 IP addresses for distribution to PCs 12 IP addresses continuing from 10.0.0.4 through 10.0.0.15 (Actually, it can support up to 253 users.) 3.4 Information from ISP Before beginning the configuration of the Router you have to know the parameters of your subscription ADS...
Page 35 - Configuring with Web Browser
Chapter 3 Installation and Configuration 29 PPPoE VC-Mux VPI/VCI, Service Name, Username, Password, and Domain Name System (DNS) IP address (it can be automatically assigned from ISP or be set fixed). PPPoE LLC VPI/VCI, Service Name, Username, Password, and Domain Name System (DNS) IP address (it ca...
Page 37 - “OK”
Chapter 3 Installation and Configuration 31 Then, click “OK” to log in. You can modify these passwords for security and management purpose. At the configuration homepage, the left navigation pane where bookmarks are provided links you directly to the desired setup page. Click on the desired item to ...
Page 39 - System Wide Settings; Per VC Settings
Chapter 3 Installation and Configuration 33 System Wide Settings Default Gateway: Enter the gateway address provided by your ISP. Per VC Settings There are eight Virtual Circuit (VC) for you to set, from VC 0 to VC 7. Before you make the settings, please scroll down to the button of the page and sel...
Page 42 - DHCP Server
I-Fly Wireless Router ADSL 36 IP Address: Default at 192.168.1.254. This is the device IP address in LAN site. If you plan to change it to another IP address to a different range of IP subnet. Please make sure your PC is also located at the same IP subnet. Otherwise, you may not be able to access th...
Page 43 - Ethernet Mode Setting
Chapter 3 Installation and Configuration 37 User Mode: There are two selections, Single User and Multi-User, for this setting. Ethernet Mode Setting Click this hyperlink to set the Ethernet mode of your LAN. There are five modes in total, including Auto Sense , 100 Full , 100 Half , 10 Full , an d 1...
Page 45 - Configuration – Virtual Server Configuration
Chapter 3 Installation and Configuration 39 Session Name: Enter the session name you set up in the session name configuration page. User’s IP: Enter the user’s IP address. Action: Select Add or Delete and then press the Submit button to add or delete any NAT user’s IP setting to/from the following t...
Page 48 - Configuration – Bridge Filtering Configuration
I-Fly Wireless Router ADSL 42 3.5.9 Configuration – Bridge Filtering Configuration Enable Bridge Filtering: Check Yes to enable this function or check No to disable. Source MAC: Enter the source MAC address. Destination MAC: Enter the destination MAC address. Type: Enter the Ethernet type. ~ Block ~...
Page 49 - 0 Configuration – DNS Configuration
Chapter 3 Installation and Configuration 43 3.5.10 Configuration – DNS Configuration A Domain Name System (DNS) contains a mapping table for domain name and IP address. In the Internet, every host has a unique and friendly name such as www.yahoo.com and IP address. The IP address is so hard to remem...
Page 54 - 7 Admin Privilege – ADSL Configuration
I-Fly Wireless Router ADSL 48 3.5.16 Admin Privilege – Learned ( Bridge ) MAC Table Aging Timeout: Enter the time period for the router to memorize MAC addresses. 3.5.17 Admin Privilege – ADSL Configuration Trellis: Default at Enabled . Handshake Protocol: Default at Autosense – G.dmt first . You ca...
Page 55 - 8 Admin Privilege – RIP Configuration
Chapter 3 Installation and Configuration 49 Wiring Selection: Default at Tip/Ring . Select Auto or A/A1 if necessary. 3.5.18 Admin Privilege – RIP Configuration RIP: Default at Disabled . Supplier: Default at True . Gateway: Default at False . Multicast: Default at False. Interval seconds : The defa...
Page 56 - 9 Admin Privilege – Password Configuration; 0 Admin Privilege – Miscellaneous Configuration
I-Fly Wireless Router ADSL 50 3.5.19 Admin Privilege – Password Configuration In factory setting, the default password for administrator is password, and that for user is also password. You can change the default password to ensure that someone cannot adjust your settings without your permission. Ev...
Page 58 - 1 Admin Privilege – Reset to Factory Default; 2 Admin Privilege – Diagnostic Test
I-Fly Wireless Router ADSL 52 3.5.21 Admin Privilege – Reset to Factory Default If for any reason you have to reset this ADSL Router back to factory default settings, be careful that the current settings will be lost and the settings are reset back to its default state. The factory default values is...
Page 60 - Test PPPoE connection
I-Fly Wireless Router ADSL 54 Test PPPoE connection This test returns PASS if your login name and password have passed authentication with your service provider. If this test returns FAIL, run this test again a few minutes after this test is completed, especially if your PPP connection has just been...
Page 61 - 3 Admin Privilege – Code Image Update; 4 Admin Privilege – Network Code Image Update
Chapter 3 Installation and Configuration 55 3.5.23 Admin Privilege – Code Image Update To upgrade the firmware of the ADSL Router, you should download or copy the firmware to your local environment first. Press the “Browse…” button to specify the path of the firmware file. Then, click “Upload” to st...
Page 63 - Chapter 4; Troubleshooting; Problems Starting Up the ADSL Router
57 Chapter 4 Troubleshooting If the ADSL Router is not functioning properly, you can refer first to this chapter for simple troubleshooting before contacting your service provider. This could save your time and effort but if the symptoms persist, then consult your service provider. Problems Starting...
Page 64 - Problems Connecting to a Remote Node or ISP
Chapter 4 Troubleshooting 58 Problems Connecting to a Remote Node or ISP Problem Corrective Action Can’t connect to ISP. Check section 3.4.12 “Admin Privilege – PPP status” to verify the line status.
Page 65 - Specification
59 APPENDIX Specification Protocols IEEE802.11b, IP, NAT, PPTP, ARP, ICMP, DHCP, PPPoE, PPPoA, IpoA, RIP1/2 and RFC1483 LAN 1 port 10/100Base-T,1 USB v1.1 port, 1 RS232 port WAN 1*RJ-11, 1 ADSL port + 1*RJ11 for phone (with ADSL Filter built-in) LED POWER, READY, ADSL, WLAN,10/100 LINK Radio IEE802....
Page 66 - ISP
Chapter 4 Troubleshooting 60 APPENDIX ISP Scenario Bridge RFC 1577 RFC 1483 R PPPoA PPPoE WAN Configuration Default Gateway 0.0.0.0 Provided by ISP Provided by ISP 0.0.0.0 0.0.0.0 VC Setting Enabled Enabled Enabled Enabled Enabled VPI 8 8 8 8 8 VCI 35 35 35 35 35 Static IP Address 0.0.0.0 Provided b...
Page 70 - Support
64 APPENDIX Support If you have any problems with the ADSL Router, please consult this manual. If you continue to have problems you should contact the dealer where you bought this ADSL Router. If you have any other questions you can contact the Atlantis Land company directly at the following address...
