Page 4 - Atlantis Land I-STORM ADSL ROUTER; Table of Content; CHAPTER 1; CHAPTER 2; CHAPTER 3; CHAPTER 4
Atlantis Land I-STORM ADSL ROUTER ii Table of Content CHAPTER 1 .......................................................................... 1 I NTRODUCTION ................................................................................................................................... 1 1.1 An Over...
Page 5 - Chapter 1 Introduction; APPENDIX A; APPENDIX B
Chapter 1 Introduction iii T ROUBLESHOOTING ......................................................................................................................... 50 Problems Starting Up the I-STORM ADSL ROUTER ............................................................ 50 Problems with the WAN ...
Page 7 - Chapter 1; Introduction
1 Chapter 1 Introduction 1.1 An Overview of I-STORM ADSL ROUTER The Atlantis Land I-STORM ADSL ROUTER router provides a high-speed ADSL port and an Ethernet port for high-speed Internet browsing. It can support downstream transmission rates of up to 8Mbps and upstream transmission rates of up to 102...
Page 8 - Package Contents; Multi-Protocol to Establish A Connection: S
Atlantis Land I-STORM ADSL ROUTER 2 dedicated local web server, even though the server now has a different IP address. In this example, the product is on the Internet and vulnerable to attacks, but the server is protected. Virtual Service can also be used to re-task services to multiple servers. For...
Page 9 - DMZ
Chapter 1 Introduction 3 Virtual Private Network (VPN): Allow user to make a tunnel with remote site directly to secure the data transmission among the connection. User can use embedded PPTP client supported by this router to make a VPN connection. Or user can run the PPTP client in PC and the route...
Page 11 - Chapter 2; Using I-STORM ADSL ROUTER; Cautions for using I-STORM ADSL ROUTER; LED
5 Chapter 2 Using I-STORM ADSL ROUTER 2.1 Cautions for using I-STORM ADSL ROUTER Do not place I-STORM ADSL ROUTER under high humidity and high temperature. Do not use the same power source for I-STORM ADSL ROUTER with other equipment. Do not open or repair the case yourself. If I-STORM ADSL ROUTER i...
Page 12 - LAN
Atlantis Land I-STORM ADSL ROUTER 6 2.3 The Rear Ports Port Meaning 1 Power (jack) Connect the supplied power adapter to this jack. 2 LAN (RJ-45 connector) Connect a straight Ethernet cable to this port when connecting to a LAN such as an office or home network. Connect the supplied crossover cable ...
Page 13 - Chapter 3; Configuration; Before Configuration
7 Chapter 3 Configuration I-STORM ADSL ROUTER can be configured with your Web browser. The web browser is included as a standard application in following operation systems, UNIX, Linux, Mac OS, Windows 95/98/NT/2000/Me, etc. The product provides a very easy and user-friendly interface for configurat...
Page 15 - Chapter 3 Configuration; Configuring PC in Windows NT4.0
Chapter 3 Configuration 9 5. Then select the DNS Configuration tab. 6. Select the Disable DNS radio button and click “OK” to finish the configuration. Configuring PC in Windows NT4.0 1. Go to Start / Settings / Control Panel . In the Control Panel, double- click on Network and choose the Protocols t...
Page 16 - Configuring PC in Windows 2000
Atlantis Land I-STORM ADSL ROUTER 10 3. Select the Obtain an IP address from a DHCP server radio button and click OK . Configuring PC in Windows 2000 1. Go to Start / Settings / Control Panel . In the Control Panel, double- click on Network and Dial-up Connections . 2. Double-click LAN Area Connecti...
Page 18 - Configuring PC in Windows XP
Atlantis Land I-STORM ADSL ROUTER 12 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration. Configuring PC in Windows XP 1. Go to Start / Control Panel (in Classic View) . In the Control Panel, double-c...
Page 20 - Factory Default Settings; Device IP Network settings in LAN site; ISP setting in WAN site
Atlantis Land I-STORM ADSL ROUTER 14 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration. 3.2 Factory Default Settings Before you configure this I-STORM ADSL ROUTER , you need to know the following de...
Page 22 - Information from ISP; Relaying; Configuring with Web Browser in Router Mode; Go; “OK”
Atlantis Land I-STORM ADSL ROUTER 16 3.3 Information from ISP Before you start configuring this device, you have to check with your ISP what kind of service is provided such as PPPoE, PPPoA, RFC1483, IPoA, or PPTP-to-PPPoA Relaying. Gather the information as illustrated in the following table and ke...
Page 23 - Logout
Chapter 3 Configuration 17 At the configuration homepage, the left navigation pane where bookmarks are provided links you directly to the desired setup page, including LAN, WAN, System, Firewall, VPN, Virtual Server, Advanced, Status, Help and Logout . Click on the desired item to expand the page in...
Page 24 - IP Address
Atlantis Land I-STORM ADSL ROUTER 18 IP Address IP Address: Default at 192.168.1.254. This is the device IP address in LAN site. If you plan to change it to another IP address to a different range of IP subnet. Please make sure your PC is also located at the same IP subnet. Otherwise, you may not be...
Page 25 - ISP; Encapsulation Method:
Chapter 3 Configuration 19 ~ Disable: Check to disable I-STORM ADSL ROUTER to distribute IP Addresses to the local network. If you check this selection, Disable , remember to specify a static IP address, subnet Mask, and DNS setting for each of your local computers. Be careful not to assign the same...
Page 30 - DNS; Obtain DNS address automatically
Atlantis Land I-STORM ADSL ROUTER 24 It can be used to connect and establish a PPTP tunnel between PPTP client on LAN and router. The router will convert and map the PPTP packet from/to PPP packet. Router establishes a PPPoA connection with ISP. DNS A Domain Name System (DNS) contains a mapping tabl...
Page 31 - Password; case sensitive
Chapter 3 Configuration 25 3.4.3 System Password In factory setting, there is no password protection when user accesses I-STORM ADSL ROUTER . It is recommended that you change the default password <BLANK> to ensure that someone cannot adjust your settings without your permission. <BLANK>...
Page 32 - Time Zone; “Browse...”
Atlantis Land I-STORM ADSL ROUTER 26 Time Zone The router does not have a real time clock on board; instead, it uses the simple network time protocol (SNTP) to get the current time from the SNTP server in outside network. Please choose your local time zone and click Apply button. You will get the co...
Page 33 - Factory Setting; Reboot
Chapter 3 Configuration 27 Then, click “Upgrade” to start upgrading. When the procedure is completed, the router will reset automatically to make the new firmware work. Factory Setting If for any reason you have to reset this I-STORM ADSL ROUTER factory default settings, be careful that the current ...
Page 34 - Packet Filter; IP address; Port number
Atlantis Land I-STORM ADSL ROUTER 28 button. Each time you reboot your I-STORM ADSL ROUTER , the following figure will appear. Please wait 25 seconds for auto-reconnection. 3.4.4 Firewall User can decide to enable this firewall function including Packet Filter, Block Hacker Attack, and Block WAN req...
Page 35 - Outgoing
Chapter 3 Configuration 29 This configuration program allows you to set up different filter rules up to 20 for different users based on their IP addresses or their network Port number. The relationship among all filters is “or” operation, which means the router checks these different filter rules on...
Page 36 - Block Hacker Attack
Atlantis Land I-STORM ADSL ROUTER 30 Active: Choose “Yes” to enable the rule, or choose “No” to disable the rule. Packet Type: Specify the packet type (TCP, UDP, ICMP or any) that the rule will be applied to. Select TCP if you want to scope for the connection-based application service on the remote ...
Page 37 - Block WAN Request/URL Filter
Chapter 3 Configuration 31 - IP Spoofing - Ping of Death (Length > 65535) - Land Attack (Same source / destination IP address) - IP with zero length - Sync flooding - Smurf Attack (ICMP Echo with x.x.x.0 or x.x.x.255) - Snork Attack - UDP port loop-back - TCP NULL scan Block WAN Request/URL Filte...
Page 40 - Remote Config
Atlantis Land I-STORM ADSL ROUTER 34 3.4.7 Advanced Remote Config Check “Enable” if you want to configure your I-STORM ADSL ROUTER from any PC in the Internet world with a web browser. To configure this router remotely, use the URL ”http://WAN IP address:33659” where WAN IP address is the IP address...
Page 41 - Dynamic Routing; Static Routing
Chapter 3 Configuration 35 Dynamic Routing The dynamic routing function of the router can be used to allow the router to automatically adjust to physical changes in the network’s layout. The router uses the dynamic RIP protocol. It regularly broadcasts routing information to other routers on the net...
Page 43 - System Status; “Connect”; “Disconnect”
Chapter 3 Configuration 37 3.4.8 Status System Status Display the current LAN, WAN, and ADSL connection status. The first line under the WAN segment displays the WAN-ISP protocol you set. You can see the status of connection from its right-side column. As for “PPPoE” and “PPPoA” protocol, the right ...
Page 44 - Device Info; “Refresh”; “Clear”
Atlantis Land I-STORM ADSL ROUTER 38 Device Info Display the current Firmware version and MAC address of your I-STORM ADSL ROUTER . System Logs Display the system logs cumulated till the present time. You can trace the historical information through this function. Refresh / Clear: Click “Refresh” to...
Page 45 - Security Logs; DHCP Table
Chapter 3 Configuration 39 Security Logs Display the information of security logs. If hacker attacks your sever, he will be isolated by the firewall function and the router will record related information. Hence, you know where the hacker comes from. Refresh: Click “Refresh” to get the latest inform...
Page 46 - Configuring with Web Browser in Bridge Mode
Atlantis Land I-STORM ADSL ROUTER 40 3.4.9 Help/ Logout After click on the hyperlink of “Help” in the left pane, the following html page will jump out. This page would be a good reference as you precede the configuration. 3.5 Configuring with Web Browser in Bridge Mode Open the web browser, enter th...
Page 50 - Upgrade; “Upgrade”
Atlantis Land I-STORM ADSL ROUTER 44 Upgrade To upgrade the firmware of I-STORM ADSL ROUTER , you should download (from www.atlantisland.it ) or copy the firmware to your local environment first. Press the “Browse…” button to specify the path of the firmware file. Then, click “Upgrade” to start upgr...
Page 54 - Changing Password
Atlantis Land I-STORM ADSL ROUTER 48 Refresh / Clear: Click “Refresh” to get the latest information of system logs, or click “Clear” to eliminate all the system logs showed on this screen. 3.5.6 Help After click on the hyperlink of “Help” in the left pane, the following html page will jump out. This...
Page 55 - Firmware Upgrade
Chapter 3 Configuration 49 Please note that the maximum input for password is 8 alphanumeric characters long. Since it is case sensitive , be sure that you remember whether a letter is in upper or lower case and make sure that your Caps Lock is off. 3.7 Firmware Upgrade To upgrade the firmware of I-...
Page 56 - Chapter 4; Troubleshooting; Problems Starting Up the I-STORM ADSL ROUTER
50 Chapter 4 Troubleshooting If the ADSL Router is not functioning properly, you can refer first to this chapter for simple troubleshooting before contacting your service provider. This could save your time and effort but if the symptoms persist, then consult your service provider. Problems Starting...
Page 57 - Problems Connecting to a Remote Node or ISP; Problem
51 Problems Connecting to a Remote Node or ISP Problem Corrective Action Check section 3.4.8 “System Status” to verify the line status. Can’t connect to a remote node or ISP. In section 3.4.7 “Remote Config” , verify your login name and password for the remote node.
Page 58 - Specification
52 APPENDIX A Specification Protocols IP, NAT, PPTP, ARP, ICMP, DHCP, PPPoE, PPPoA, IpoA, PPTP client, RIP1/2 LAN Port RJ-45, 1 ports 10/100Base-T WAN Port RJ-11, 1 ADSL port LED Indicators PPP, LAN-ACT, LAN-COL, ADSL, Power Input Power 5V DC @1.5A Power Consumption < 6 watts Agency and Regulator...
Page 59 - Product Support
53 APPENDIX B Product Support If you have any problems with the ADSL Router, please consult this manual. Most problems can be resolved by using the Troubleshooting chapter. If you continue to have problems you should contact the dealer where you bought this ADSL Router. If you have any other questio...
